Manual

Page 1

Battery

V21

V42

USP

10/05/2012

Technical help is available: Monday - Friday from 07:00 - 19:00 (GMT)

Saturday from 09:00 - 13:00 (GMT)

01273 811011 support@paxton.co.uk

Technical Support

Paxton Net2

control unit

Back-up battery

Tamper Switch

Layout

12V DC Outputs

Ratings Label

Documentation on all Paxton products can be found on our website - http://www.paxton.co.uk/

Paxton

Ins-30154 24V AC/DC power supply with Net2 ACU

24V AC/DC input

24V DC Output

Input supply failure alarm

PAGE 1
0/05/2012 Paxton Ins-30154 24V AC/DC power supply with Net2 ACU Technical Support 01273 811011 support@paxton.co.uk Technical help is available: Monday - Friday from 07:00 - 19:00 (GMT) Saturday from 09:00 - 13:00 (GMT) Documentation on all Paxton products can be found on our website - http://www.paxton.co.
PAGE 2
5 mm 116 mm Fitting 1. Screws and wall plugs are provided in a fitting kit. With reference to the diagrams, determine where the top, central mounting position is required and drill a hole suitable for a No 8 wall plug. 2. Tap in one of the wall plugs. 3. Put in one of the long screws, leaving a suitable gap to the wall surface and slide the cabinet over it. 320 mm 4. Mark the hole positions for the lower 2 screws. Metal Cabinet 5. Remove the cabinet and drill the additional holes. 268 mm 6.
PAGE 3
Status Lights Green This LED is on when the input supply is healthy. Red This LED is on when the input supply has failed - Power is being supplied by the battery. Features Battery backup The cabinet can accommodate a 12V / 7Ah battery. Fast/Trickle charge The battery is continuously charged to keep it at maximum capacity. Deep discharge protection If battery voltage falls below 9.5V, it will automatically disconnect - Red LED goes out.