User's Manual

3
4
6
5
Step 6: Inserting the motor
Pass the motor through the central hole within
the door, making sure to pass the motor lead
through the hole rst.
Step 5: Fitting the strike plate
Close the door to mark the horizontal line of the
strike plate.
Measure one half of door thickness from door
stop to mark vertical center line of the strike.
Drill 1” (25.4mm) hole, 1/2” (12.7mm) deep at
intersection of horizontal and vertical center
lines.
Cut out jamb 3/32” (2.4mm) deep or until the
strike is ush with jamb. Tighten the strike plate
screws securely.
Step 4: Fitting the door latch
Attach the latch using the screws provided.