User's Manual

PAGE 3
Step 9 - Fitting the rear cover
Present the front lock assembly to the door passing
the wiring harness through the
5
/8" hole.
Present the rear lock assembly to the door and join
the two parts together with the two mounting screws.
Step 5 - Mounting on the door
Step 6 - Wiring
Plug the wiring harness into the socket in the rear
lock assembly.
Locate the top of the cover over the housing and push
ush to the door.
Clip in the 4 x AA batteries with reference to the label
displayed below the holder assembly.
Step 8 - Fitting the batteries
Where a contact swich is tted, connect the wires to
the terminal block provided on the pcb.
Step 7 - Wiring (contact switch option)
Mounting screws are provided in three lengths.
Short - Door width 1
1
/4" to 1
3
/4"
Med - Door width 1
1
/2" to 2"
Long - Door width 1
3
/4" to 2
1
/4"