User's Manual

Issuing tokens
1. Across each double page there are ‘pairs’ of cards - a ‘User card’ and a corresponding ‘Shadow card’.
2. Write the name of the user on the shadow card.
3. Issue the matching user card to the user.
4. Keep the card pack containing the shadow cards in a safe place.
1
2
3
4
Bar a user
1. When a card is lost or stolen it is important to bar the card from your system to avoid unauthorized access.
2. To bar a card or token take it’s corresponding shadow card from the card pack.
3. Swipe the shadow card through the reader. This will remove the lost card or token from your system.
4. A barred card can re-validated by swiping the enrolment card followed by the user card through the reader.
Door held open
A button on the inside allows the internal handle to be held in the unlocked position.
NOTE: The Fail Open release card has the same function as a door held open card.
1. Take the fail open release function card from the starter pack
2. Present the card to the reader. The reader will beep for about a second
3. The door is now set to be permanently open.
4. To relock the door, present the card again, the reader will bleep once.
1 2 3 4
BEEP!
BEEP!
Fail open release card
This card is used with
systems where a fail open
electric release is used for
safe operation in the event of
a fire. Swipe the card through
the reader to drive a fail open
release or maglock. Swipe
the card again to revert to fail
closed operation.
Fail open release card
This card is used with
systems where a fail open
electric release is used for
safe operation in the event of
a fire. Swipe the card through
the reader to drive a fail open
release or maglock. Swipe
the card again to revert to
fail
closed operation.
Fail open release card
This card is used with
systems where a fail open
electric release is used for
safe operation in the event of
a fire. Swipe the card through
the reader to drive a fail open
release or maglock. Swip
e
the card again to revert to
fail
closed operation.
The external handle is free to move and is only engaged once access has been granted.
The inside handle is always engaged.
When access has been granted, the unit will ash the Green LED and the handle will
then engage. The unit will beep during this time to advise the user that access has been
permitted. This default time (4 seconds) can be changed with the ‘door open time’ card.
Presenting an invalid or barred card will ash the Red LED and sound a low tone. Access is
denied.
ALARMS - The handle must be horizontal to operate the latch. If it is not horizontal when a
valid card is presented, the LED will ash Amber until the handle is again horizontal when
the latch will then release.
Normal Operation - LED Indications