User's Manual
All tokens will now be validated.
Tokens can now be issued to users
Present the enrolment card
To bar a user:
The user card is now barred
Present/swipe user’s shadow card
Adding an additional Proximity card pack. You need to be in possession of a valid enrolment
card for this system. Present this enrolment card to the reader and the Amber LED will ash
with the Green & Red LEDs off. Present the Enrolment card from the new card pack. The reader
will beep and all LEDS will be lit. The additional cards will now be valid. Repeat this with each
reader and with any additional card packs. Any valid enrolment card can be used to add further
packs. If an incorrect enrolment card is used to start the process, the Red LED will be lit and the
reader will produce a squeak sound as it rejects the card.
PROXIMITY with TOUCHLOCK mode
(i) The unit must rst be initialised in TOUCHLOCK mode: See TOUCHLOCK section
IMPORTANT NOTE: Do not set the Programming Code to 123456
(ii) Before enrolling a card pack, set up the required operating mode, as follows:
(iii) Now present enrolment card
Card plus PIN. A card requires a 4 digit PIN to be assigned to it before it will work, as follows:
Present
enrolment card
Present
user card
Enter PIN
Re-Enter PIN
Card plus Code. User gains access by presenting a valid token and then entering a valid code.
Card or Code. User gains access by presenting a valid token or entering a valid code.
See Touchlock programming - Option 8 to set codes. (4 digits) - Option 2 to enable multiple codes.
1
Card plus PIN Card or CodeCard plus code
2
3
OR OR
Enter 6 digit
Programming
Code
Hold for 3 secs
1
Flashing Amber LED
Flashing Yellow/Green LED
Flashing Yellow/Green (faster) LED
IMPORTANT: Before presenting a PROXIMITY card to the reader, you must rst press
the POWER - - key or briey depress the handle.
The reader is then active for 2 seconds and will ash all the LEDS during this period.
This is to ensure maximum battery life.
A user can be re-validated by showing the enrolment card followed by the user
card or re-entered if used in Card+PIN mode.