User's Manual

This box can be used to write down the Programming Code for future reference.
Ensure that this information is stored in a secure place.
Choose a 6 digit Programming Code and load this into the unit as follows:
IMPORTANT NOTE: Do not set the Programming Code to 123456
The programming code must not contain the same string of digits as the user code.
The default user code is 1234 - therefore the programming code must not be set to 123456
6 digit Programming
Code
The factory User Code is now set to 1234
6 digit Programming
Code
You can now set up the user codes and features using the programming chart.
Example: - Setting a user code to unlock the door under Normal condition
Enter user code
4-8 digits
Re-enter
user code
4
8
Enter 6 digit
Programming
Code
Hold for 3 secs Normal
X
Single or multiple
codes
Silent operation
20 wrong keystrokes
= 60 second lockout
Door open time
(seconds)
Change
Programming Code
Set a
user code
Data Reset (except
Programming code)
OR
One code only
Multiple codes allowed
Silent
Beep on
OFF
ON
Enter time in seconds
(default = 05, max = 60)
Enter user code
4-8 digits
Re-enter
user code
Enter 6 digit
Programming
Code
= Delete
= Normal
= Toggle
Enter 6 digit
Programming
Code
Re-enter 6 digit
Programming
Code
6
OR
OR
X
2
4
6
OR
OR
2
2
2
2
3
4
5
6
9
8
6
6
9
START - Enter the 6 digit Programming Code and hold down a function key
----- for 3 seconds. - The unit beeps and the LED ashes faster.
Continue the key sequence to set the option - The keypad returns to operating mode.
= default setting
= Hold down for 3 secs
1
Card
plus
PIN
Card
or
Code
Card
plus
code
2
3
OR OR
1
Combined Card &
Keypad modes
INITIALISING A NEW SYSTEM
TOUCHLOCK MODE