User's Manual
Page 5
Wireless Net2Air activity is signalled by a Blue LED. This will ash each time the Easyprox nano
communicates with the Net2 software.
Presenting a valid user card to the unit will cause the LED to ash Green briey and the handle will then
engage. The unit will beep during this time to advise the user that access has been permitted.
The external handle is only engaged once access has been granted. The inside handle is always engaged.
Normal Operation - LED Indications
A button on the inside allows the internal handle to be held in the unlocked position.
Software conguration
Name: Each reader can be named individually if required.
Reader operating mode: Set the operating mode.
Timed operating modes: A different operating mode can
be congured within a time window.
Reader: Local settings for the reader.
Output: Congures the lock for timed release or toggle mode.
Events: Shows the events for this control unit only.
Access Rights: Lists users who have access through this door.
Door name: Name the ACU.
Door open time: Set the door open time.
Unlock the Door during: Permanently unlocks
the door while this time zone is active. - Should
be set to ‘At No Time’ for normal user operation.
Blue
Green ash + beep
Red ash + low beep
Red ash 3 times
Amber constant ashing
Red constant ashing
Indicates wireless communication with the Net2 software
A valid user card has been presented and the handle is engaged
An invalid user card has been presented - No access granted
Activity has been sensed but no user card has been presented
A valid user card has been presented - the handle is not horizontal and so the latch cannot release
The handle is being held down - The latch cannot relock
LED indications