User's Manual

Page 2
Decide on the lock height and mark this on the door.
Fold the template along one dotted line and tape it to
the door with the ‘Centreline of Latch’ at the required
height. Mark the 4 x 3/8”and 1 x 1” holes. Remove the
template, fold along the other dotted line and apply it
to the other side of the door at the same height. Mark
the holes as before.
Remove the access plate at the rear of the unit by
removing the top standoff screws. Push the battery
pack lead onto the white power plug.
Fit the battery pack into the unit and replace and
secure the access plate.
Installing the hardware
Step 1 - Marking out
Step 2 - Drilling
Step 3 - Fitting the latch
Step 4 - Fitting the battery pack
Drill a 1” hole in the door edge at least 3” deep to
accept the latch.
Drill the 4 x 3/8” holes for the mounting screws and
a 1” hole for the square bar. To ensure accuracy
you should drill these holes from both sides of the
door towards the centre. This also avoids the risk of
damaging the door face when the drill breaks through.
Slide in the latch and draw around the faceplate.
Remove the latch and score the outline with a Stanley
knife to avoid splitting the wood when chiselling.
Chisel a rebate allowing a ush t for the latch. Re-t
the latch with the plunger facing away from the door
frame and secure with two latch screws.
Cut the square bar to length (Door thickness + 3/4”)
and slide into the latch.



