User's Manual
9
The declaration of conformity is available on request. Contact details are provided at: http://paxton.
info/596
These products are not suitable for retail sale. All warranties are invalid if these products are not installed
by a competent person.
North America:-
Product Compliance and limitations
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation. Changes or modications not expressly approved by the party
responsible for compliance could void the user's authority to operate the equipment.
Changes or modications not expressly approved by the party responsible for compliance could void the user’s author-
ity to operate the equipment.
The Net2Air Bridge has been designed and complies with the safety requirements for portable (<20cm) RF exposure in
accordance with FCC rule part 2.1093 and KDB 447498 D01 as demonstrated in the RF exposure analysis. Installers must
ensure that this device must not be co-located or operated in conjunction with any other antenna or transmitter except
in accordance with FCC multi-transmitter product procedures.
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two
conditions:
(1) this device may not cause interference, and (2) this device must accept any interference, including interference that
may cause undesired operation of the device.
The Net2Air Bridge has been designed and complies with the safety requirements for RF exposure in accordance with
RSS-102 as demonstrated in the RF exposure analysis.
This product should not be installed within 3 metres of other wireless equipment operating on a 2.4Ghz frequency.
To ensure optimum performance other wireless networks should avoid WiFi channels 11, 12 and 13 to reduce the
possibility of interference.
With reference to the signal diagram the unit should be located at a distance as shown within the Green area. Per-
formance may be reduced with an increase in distance as shown by the Amber area. The unit should not be used at
distances shown by the Red areas.
To clear all settings back to their factory default, including clearing the current IP address and setting the bridge
to acquire new addresses using DHCP, power on the unit with the reset button held down for 3 seconds. This is
located at the rear of the unit through a small hole beneath the power connection. The unit will beep to acknowledge
once the reset is complete.
FCC Compliance
IC Compliance
Installation guidelines
Data Reset
Wiring methods shall be in accordance with the National Electrical Code (ANSI/NFPA70), local codes, and the authorities
having jurisdiction.
ins-20004.indd 9 25/02/2016 11:26:36