User's Manual
PAGE 3
Following the completed installation of this equipment, no further maintenance or testing is required.
It is advisable to ensure that any third party backup power supplies or recovery procedures are checked regularly
to ensure that the operation of the Paxton system is not compromised.
Maintenance
Part number Description
Not required Fits to studs on customer facia
Parts Kit
Reader installation and test
The panel mount reader is designed to t into a door entry panel. It ts behind a reader aperture of industry standard
size (40 mm x 40 mm) and is supplied with a polycarbonate window to match. See front page for tting detail.
Holes are provided in each corner to t over 4 posts set in a 49 mm square formation. Fixings are not provided as
they will normally be supplied with the panel.
When powered up, the reader will beep and all the LED's should display. Presenting a user card to the reader will
cause the LED's to briey change to a single Green or Red LED.
Check the following FAQs section for assistance if any problems are encountered.
FCC Compliance
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation. Changes or modications not expressly
approved by the party responsible for compliance could void the user's authority to operate the equipment.