User's Manual
Table Of Contents
- 1）Magnetic Stripe Card
- Put magnetic stripe side of magnetic card towards device interior, swipe the card with a steady speed during through magnetic reader slot. (Support bi-directional swiping)
- 2）IC Card
- Put IC card chip side upward, push-in IC card slot and to bottom.
- Put the contactless card into the sensing areaat the top of LCD
- 2. Installation and Usage Tips
- 1）Avoid putting the terminal in direct sunlight, high temperature, moist, or dusty environment.
- 2）Forbid non-professional to repair the terminal.
- 3）Before insert the card, please check internal and around of IC card slot. when you foundsome suspicious objects , must reportto related administrator.
- It is highly recommended to enter password as following ways:
- 1）Set up peep shields.Enter password with shield by the structures of cashierdesk;
- 2）Place the POS terminal at an appropriate angle and make sure it is difficult to peer the password. For example, the POSwas installed above the movable bracket.
- 3）In enter password perspective, avoid surrounding video surveillance;
- 4）Pastetext instructions to remind the customers to shelter with body or palm when enter password.
- 5）Merchants can also choose other ways to protect the customer input password.
- The devicesupports 1/2/5.5/11/6/9/12/18/24/36/48/54 Mbps for WIFI2.4GHz b/g
- and MCS0~MCS7 for WIFI n-20MHz of transmitting speed and operating frequency is 2412MHz~2462MHz with 11 channels.The device of RF carrier is DSSS (DBPSK / DQPSK / CCK) and OFDM (BPSK / QPSK / 16QAM / 64QAM)
- Bluetooth, frequency: 2402-2480MHz, transmitting power: 9.0dBm
- WIFI, frequency: 2412-2462MHz, transmitting power: 15.0dBm
- The CLRC663is a highly integrated transceiver IC for contact|ess communication at 13.56MHz.This transceiverIC utillzes an outstanding moduation and demodulation conoept completely integrated for different kinds of contactless comFnunication methodsand...
- The CLRC663 suppors MIFARE1K,MIFARE4K,MIFARE UlraIight,MIFARE UltaIoht C,MlFARE PLUS and MIFARE DESFire products.The CLRC663 supports contactless con1munication and uses the MlFARE highertransfer speeds of up to 848 kbiVs in both directions.
- 4. Icon shows
- Do not throw away, need professional recycling.
- Class II Equipment
- For indoor use only
- Energy Efficiency Marking
- The MAINS plug is used as the disconnected device.
- FCC Regulations:
- Déclaration d'exposition aux radiations: Cet équipement est conforme aux limites d'exposition aux rayonnements IC établies pour un environnement non contrôlé. Cet équipement doit être installé et utilisé avec un minimum de 20 cm de distance entre la s...
Industry Canada statement
This device complies with Industry Canada license-exempt RSS standard(s). Operation is
subject to the following two conditions:
1) this device may not cause interference, and
2) this device must accept any interference, including interference that may caus
e
unde
sired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils
radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes:
1) l'appareil ne doit pas produire de brouillage, et
2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si l
e
br
ouillage est susceptible d'en compromettre le fonctionnement.
This device and its antenna(s) must not be co-located or operating in conjunction with any
other antenna or transmitter, except tested built-in radios
.
C
et appareil et son antenne ne doivent pas être situés ou fonctionner en conjonction avec une
autre antenne ou un autre émetteur, exception faites des radios intégrées qui ont été testées.
The County Code Selection feature is disabled for products marketed in the US/ Canada.
La fonction de sélection de l'indicatif du pays est désactivée pour les produits
commercialisés aux États-Unis et au Canada.
R
adiation Exposure Statement:
This equipment complies with IC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance 20cm
between the radiator & your body.
D
éclaration d'exposition aux radiations:
Cet équipement est conforme aux limites d'exposition aux rayonnements IC établies pour un
environnement non contrôlé. Cet équipement doit être installé et utilisé avec un minimum de 20
cm de distance entre la source de rayonnement et votre corps.