User's Manual

PAX TECHNOLOGY INC.
Available Accessories
Cleaning the Device
10
Cleaning the Device
WARNING:
Do not use industrial strength or abrasive cleaner as it may
damage or scratch the screen.
Do not immerse device in water (or liquid.)
Do not spray water or cleaner into the MSR slot, Smart Card
Reader or ports.
To clean screen, apply distilled water or mild glass cleaner
onto a soft, lint-free cloth and gently wipe terminal screen.
To clean terminal, apply distilled water or plastic-safe cleaner
onto a soft, lint-free cloth and gently wipe terminal.
11
Available Accessories
RS232 Cable
200204020000140
Requires Power Supply
USB Cable
200204020000141
Requires Power Supply
Power Supply
200310110000070
Requires Power Cord
Power Cord
200311020000023
Requires Power Supply
Stylus Pen
200209090000929
Stylus Holder Plug
200209090000930
Decorative Privacy
Shield Plug
2002090900001037
Privacy Shield
200209060000040
PAX TECHNOLOGY INC.
9
10
This docume nt is provided to you for informational purposes
only. All features and specifications are subject to change
without notice. PAX's name and PAX's logo are registered
trademarks of PAX Technology Inc. All rights reserved.
PAX Technology Inc.
4901 Belfort Road, Suite 130
Jacksonville, FL 32256, US A
T: 877-859-0099
W: www.pax.us
E: sales@p ax.us
P/N:200312000000224
ISED Notice
This device complies with Innovation,Science and Economic
Development Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions:
1) this device may not cause interference,and
2) this device must accept any interference,including
interference that may cause undesired operation of the
device.
Le présent appareil est conforme aux CNR Innovation,
Sciences et Développement économique Canada
applicables aux appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes:
1) l'appareil ne doit pas produire de brouillage,et
2) l'utilisateur de l'appareildoit accepter tout
brouillageradioélectriquesubi, mêmesi le brouillageest
susceptible d'en
This Class B digital apparatus complies with Canadian
ICES-003.
Cetappareilnumérique de la classe B estconforme à la norme
NMB-003 du Canada.
IC: 11689A-PX5RF
FCC Regulations:
This mobile phone complies with part 15 of the FCC Rules.
(1) Operation is subject to the following two conditions:
This device maynot cause harmful interference,and
(2) thisdevice must accept any interference received,
including interference that maycause undesired operation.
This mobile phone has been tested and found to comply with
the limits for a Class B digital device,pursuant to Part 15 of
the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates,uses and
can radiated radio frequency energy and,if not installed and
used in accordance with the instructions,may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following
measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and
receiver.
-Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician
for help.
FCC Note:
Caution: Changes or modifications not expressly approved
by the party responsible for compliance could void the user's
authority to operate the equipment.
RF Exposure Information
This device meets the government's requirements for
exposure to radio waves.
This device is designed and manufactured not to exceed the
emission limits for exposure to radio frequency (RF) energy
set by the Federal Communications Commission of the U.S.
Government.
This device complies with FCC radiation exposure limits set
forth for an uncontrolled environment.
The equipment is to be connected only to PoE network
without routing to the outside plant
ISED Radiation Exposure Statement
This EUT is very low power and compliance withRSS-102
exemption requirements.
Ce MAE esttrèsfaible puissance et de la conformité aux
exigencesd'exemptionCNR-102.