User's Guide

PAX3
Model: X301
RF: 2402-2480MHz; 2mW
Rated: 5Vdc, 1500mA, 3300mAH
Class III Device
Operating temperature:
32 °F - 1
13 °F (0 °C - 4
5 °C)
Manufacturer: PAX Labs, Inc.
660 Alabama St., Second Floor
San Francisco, CA 94110, U.S.A.
FCC STATEMENT: FCC ID: 2AJWD-X301
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may
cause undesired operation.
Note: Modification to this product will void the users’ authority to operate this
equipment.
FCC IMPORTANT NOTES:
FCC RADIATION EXPOSURE STATEMENT
This equipment complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment. This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
This equipment complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may
cause undesired operation.
The devices must be installed and used in strict accordance with the manufacturer’s
instructions as described in this document.
CANADA: WARNING STATEMENT IC: 22010-X301
This Class B digital apparatus complies with Canadian ICES-003 .
This device complies with Industry Canada license-exempt RSS standard(s). Operation
is subject to the following two conditions:
(1) This device may not cause interference, and
(2) This device must accept any interference, including interference that may cause
undesired operation of the device.
RF EXPOSURE WARNING: The equipment complies with RF exposure limits set forth
for an uncontrolled environment. The antenna(s) used for this transmitter must not be
co-located or operating in conjunction with any other antenna or transmitter.
IMPORTANT SAFEGUARDS SAVE THESE INSTRUCTIONS
WARNING: To avoid injury or damage to personnel or items, observe the following:
• The device is not to be used by children, pregnant or lactating women.
• Keep your PAX® device and its components out of the reach of children and pets.
• The device is not to be used by persons with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless they have been given
supervision or instruction. Patients taking prescription medications should consult
their physicians prior to using a PAX device.
•
During and after use, the temperature on the heater side can reach up to 464 °F
(240 °C). Do not touch the heater bowl and use caution when touching the metal
components of the oven lid and optional adaptor.
• Do not operate your PAX device with the oven lid open or ajar as the oven is extremely
hot when in use.
• Turn the power off when not in use or left unattended.
• Use your PAX device only with legal plant material.
• Do not use or leave the device in hot places such as where the device is exposed
to direct sunlight, in a closed vehicle on a hot day, or near a heater. If this is not
observed, leakages, overheating or bursting may cause fire, burns or other injuries.
• Do not use your PAX device if it is unusually hot to the touch.
• Do not use your PAX device if it becomes immersed in any liquid.
• Stop using your PAX device if the enclosure has cracks, dents, openings, is swollen
or shows any other signs of misuse. Discontinue use immediately and promptly and
properly dispose of the device.
• Do not disassemble or tamper with your PAX device. Any inappropriate, incorrect, or
irresponsible use will void any warranty and can result in serious injury. Battery is not
intended to be replaced.
• Do not use your PAX device without the mouthpiece on the device.
• Do not expose your PAX device to extremely high or low temperatures.
• Do not store your PAX device or any of its components in or near heat sources.
• Do not use your Pax device if you have respiratory issues as inhalation of material
with this product may aggravate existing respiratory conditions.
• Speak to a healthcare professional prior to using your PAX device if you have any
concerns about vaporization.
• Use your PAX device only with material that is legal under the laws applicable to
your location.
• Do not use your PAX device if it is unusually hot to the touch, carefully check vapor
temperature prior to full inhalation.
• The USB charger cable has exposed pins which could be accidentally shorted.
Remove USB cable from host computer or USB adaptor when not charging the device.
• Do not attempt to remove any content from the oven or clean your PAX device until the
oven has completely cooled.
• Do not place your PAX device in a dishwasher, washing machine or dryer.
• Charge your PAX device using a computer, power hub or power supply (marked “LPS”
or “Class 2”), with a rated output of 5Vdc, 1500mA min (2.5A max) that is certified
by a recognized testing laboratory.
• The charging cable should only be used with a computer or power hub or power supply
as stated above.
• Your PAX device should only be charged indoors. Do not charge the product outside or
in the rain. The charging cable is for INDOOR USE ONLY.
• Carrying and handling the device: This device contains sensitive components. Do not
drop, throw, disassemble, open, crush, bend, deform, puncture, shred, microwave,
incinerate, paint, or insert foreign objects into this device.
• Portable electronics containing Lithium Ion batteries present rare, but potentially
serious safety hazards, especially under hot or cold conditions. Charging of the PAX
device should only be performed at temperatures between 32 °F and 113 °F (0 °C
and 45 °C). To assure personal and property safety, never charge your PAX device
below 32 °F (0 °C) or above 113 °F (45 °C).
• Your PAX device contains a Lithium-ion battery and should be recycled or disposed of
in accordance with local requirements to avoid potential injury and/or environmental
harm. Do not dispose of the battery or any component of your PAX device in a fire as it
could cause an explosion or other serious injury.
BATTERY DISPOSAL: Lithium Ion batteries contain elements that may pose health
risks to individuals if they are allowed to leach into the ground water supply. In some
countries, it may be illegal to dispose of these batteries in standard household waste.
Fortunately, many recycling facilities exist that process lithium ion batteries, in part due
to the value of the materials contained within the individual cells. In the United States
and Canada, a large network of over 30,000 battery drop-off locations may be found
at www.call2recycle.org.
To render the product safe for transport, apply non-conductive tape over any exposed
connectors to prevent the accidental shorting of the positive and negative terminals of
the battery during transport. Do not attempt to remove the battery from this device; to
dispose of battery, contact pax.com/support to return entire device to a PAX designated
recycling location. NEVER dispose of the battery in a fire or incinerator, as the battery
may catch fire and NEVER dispose of the battery in a fire or incinerator, as the battery
may catch fire and explode.
ROHS: This RoHS-compliant product conforms to the European Union Restriction
of the Use of Certain Hazardous Substances (RoHS) in Electrical and Electronic
Equipment. Fox Factory ensures RoHS conformance by requiring supplier Declarations
of Conformity, monitoring incoming materials, and maintaining manufacturing
process controls.
WEEE: This symbol on the product(s) and / or accompanying documents means that
used electrical and electronic equipment should not be mixed with general household
waste. For proper treatment, recovery and recycling, please send this product(s) to
PAX designated collection points where it will be accepted free of charge. Alternatively,
in some countries, you may be able to return your products to your local retailer upon
purchase of an equivalent new product or with respect to products under warranty,
authorization by PAX to return product in exchange for a replacement product to be
provided free of charge.
Disposing of this product correctly will help save valuable resources and prevent
any potential negative effects on human health and the environment, which could
otherwise arise from inappropriate waste handling.
Please contact PAX customer support (pax.com/support) for details of PAX’s
designated collection point.
Penalties may be applicable for incorrect disposal of this waste, in accordance with
your national legislation.
IMPORTER OF RECORD
PAX Labs, Inc.
Chalfont St Giles, Buckinghamshire
HP8 4EY, UK.
PHONE NUMBER:
PAX USER GUIDE, LIMITED WARRANTY
INFORMATION, BATTERY RETURN
PROGRAM pax.com/support
[phone]
The Bluetooth® word mark and logos are registered trademarks owned by the
Bluetooth SIG, Inc. and any use of such marks by PAX Labs, Inc., is under license. Other
trademarks and trade names are those of their respective owners.
Modèle : X301.
Nominal : 5 Vcc, 1 500 mA, 3300mAh
Dispositif de classe III
Température d’utilisation :
0
°C à 45 °C (32 °F à 113 °F)
Fabricant : PAX Labs, Inc.
660 Alabama St., 2e étage
San Francisco, CA 94110, É.-U.
ÉNONCÉ CONCERNANT LA RÉGLEMENTATION DE LA FCC :
IDENTIFIANT DE LA FCC: 2AJWD-X301
Ce matériel a été mis à l’essai et déclaré conforme aux limites imposées à un appareil
numérique de classe B, en vertu de l’article 15 de la réglementation FCC. Ces limites
sont conçues pour assurer une protection raisonnable contre les interférences nuisibles
dans une installation résidentielle. Ce matériel génère, utilise et peut émettre de
l’énergie sous forme de fréquences radio. Si ce matériel n’est pas installé et utilisé
conformément aux instructions, il peut causer des interférences nuisibles aux
communications radio. Aucune garantie n’est néanmoins fournie quant à la production
d’interférences pour une installation particulière. La présence d’interférences peut
être déterminée en éteignant et en rallumant l’appareil. Si cet appareil provoque des
interférences nuisibles à la réception des programmes de télévision ou des ondes
radio, l’utilisateur est invité à corriger ce problème en prenant une ou plusieurs des
mesures suivantes:
• Modifier l’orientation ou déplacer l’antenne de réception.
• Augmenter la distance entre l’appareil et le récepteur.
• Brancher l’appareil à une prise d’un circuit différent de celui sur lequel est branché
le récepteur.
• Consulter le revendeur ou un technicien radio/télévision expérimenté pour obtenir
de l’aide.
L’utilisation de ce produit est assujettie aux deux conditions suivantes :
(1) Ce dispositif ne doit pas causer d’interférence nuisible;
(2) Ce dispositif doit accepter toute interférence reçue, y compris les interférences qui
peuvent causer un fonctionnement non désiré.
Remarque : La modification de ce produit annulera l’autorisation de l’utilisateur
de faire fonctionner ce dispositif.
REMARQUES IMPORTANTES CONCERNANT LA FCC :
ÉNONCÉ DE LA FCC SUR L’EXPOSITION AUX RADIATIONS
Ce dispositif est conforme aux limites d’exposition aux radiofréquences de la FCC
définies pour un environnement non contrôlé. Cet émetteur ne doit pas être situé
au même endroit qu’une autre antenne ou qu’un autre émetteur ni être utilisé
conjointement avec une autre antenne ou un autre émetteur.
Ce dispositif est conforme à la partie 15 de la réglementation de la FCC. L’utilisation de
ce produit est assujettie aux deux conditions suivantes:
(1) Ce dispositif ne doit pas causer d’interférence nuisible;
(2) Ce dispositif doit accepter toute interférence reçue, y compris les interférences qui
peuvent causer un fonctionnement non désiré.
Les dispositifs doivent être installés et utilisés en respectant rigoureusement les
directives du fabricant décrites dans le présent document.
CANADA : ÉNONCÉ DE MISE EN GARDE IC : 22010-X301
Cet appareil numérique de la classe B est conforme à la norme NMB- 003 du Canada.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux
appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions
suivantes :
(1) L’appareil ne doit pas produire de brouillage, et
(2) L’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si
le brouillage est susceptible d’en compromettre le fonctionnement.
AVERTISSEMENT D’EXPOSITION RF: L’équipement est conforme aux limites
d’exposition aux RF établies pour un incontrôlés environnement. L’antenne (s) utilisée
pour ce transmetteur ne doit pas être co-localisés ou onctionner en conjonction avec
toute autre antenne ou transmetteur.