Instructions / Assembly

5. Remove the wheels from the axles to
provide easier access to the hex nuts
and tighten the hex nuts.
6. Replace the wheels on the axles,
making sure that the longer yokes (Fig. 5)
of each wheel are turned inward. Se-
cure the wheels to the axles with the axle
caps (Fig. 6) by placing the cap over the
axle and striking the cap with a small
hammer.
7. The stand now can be moved by
lifting the end of the stand opposite the
wheels.
5050 - A
11.OD
(See Fig. 2 & 3) Do not tighten the hex nuts at this point.
3. Place a wheel (Figs. 4 & 5) on each axle of the wheel
bracket.
4. Hand tighten the hex nuts on the U-bolt while holding
the bracket and wheels at a point that holds the wheels
approximately 1/16" above the surface on which the
stand is resting.
Upright Pole
Wheel Kit Installation
Point
WARRANTY INFORMATION:
Products of The HammockSource are guaranteed to
be free of defects in workmanship and materials for
up to one year after the purchase date. Prolonged
exposure to weather conditions including snow, rain,
and humidity are not covered under the warranty
nor is damage caused by normal wear, mildew,
improper care including storage, maintenance, and
installation. If an item is found to be defective within
one year of its purchase, it will be replaced without
charge upon the return of the unit accompanied by
a sales receipt. A Return Authorization is needed for
return and may be obtained by contacting
800.334.1078.
5. Remove the wheels from the axles to
provide easier access to the hex nuts
and tighten the hex nuts.
6. Replace the wheels on the axles,
making sure that the longer yokes (Fig. 5)
of each wheel are turned inward. Se-
cure the wheels to the axles with the axle
caps (Fig. 6) by placing the cap over the
axle and striking the cap with a small
hammer.
7. The stand now can be moved by
lifting the end of the stand opposite the
wheels.
5050 - A
11.OD
(See Fig. 2 & 3) Do not tighten the hex nuts at this point.
3. Place a wheel (Figs. 4 & 5) on each axle of the wheel
bracket.
4. Hand tighten the hex nuts on the U-bolt while holding
the bracket and wheels at a point that holds the wheels
approximately 1/16" above the surface on which the
stand is resting.
Upright Pole
Wheel Kit Installation
Point
WARRANTY INFORMATION:
Products of The HammockSource are guaranteed to
be free of defects in workmanship and materials for
up to one year after the purchase date. Prolonged
exposure to weather conditions including snow, rain,
and humidity are not covered under the warranty
nor is damage caused by normal wear, mildew,
improper care including storage, maintenance, and
installation. If an item is found to be defective within
one year of its purchase, it will be replaced without
charge upon the return of the unit accompanied by
a sales receipt. A Return Authorization is needed for
return and may be obtained by contacting
800.334.1078.