Users Manual

No Zap:
Press, and then immediately release the middle button. If there is no
zap, no LED’s, and no short vibration, you typically need to charge it
with the supplied USB-C cable. If you get no zap but do see lights and
feel a short vibration, try changing the zap strength through the app. If
your Pavlok is completely unresponsive, leave off the charger for 12
hours and plug in again, repeating the steps above.
Zap Strength:
If you don’t think the zap is very strong, there are a few things you
can try: 1) Make sure your Pavlok is charged. When it is low on
battery, the zap strength is reduced. 2) Change the zap strength
through the app. 3) Increase the number of zaps with Multi-Zap. 4)
Ensure the wristband is secure so that the Pavlok touches your skin.
5) Move the Pavlok to the other side so that it touches the inside of
your arm.
Device Not Connecting to App:
If you are trying to connect the Pavlok to the app but are having issues
pairing or getting the buttons on the Remote to work, attempt the
following, then try to reconnect.
1. Forget Device from Phone: Go to your phone’s Bluetooth
®
settings. If
your Pavlok is listed under “My Devices”/”Paired Devices”, then tap
on it and choose to Forget Device/Unpair.
2. Turn your phone’s Bluetooth
®
off and then on.
3. Hard Reset the Pavlok: Press and hold the middle button for
about 10 seconds until you see red blink followed by faint yellow
f l icker.
4. Attempt to re-pair in App