Product Manual

HUB REMOTE
TOP HOT SHOE
LOCKING BOTTOM
HOT SHOE
(CAMERA BRAND SPECIFIC)
REAR DISPLAY
POWER BUTTON
SYNC JACK
ROTARY WHEEL
CHARGING PORT
The HUB remote (sold separately) is a new addition to our CyberSync remote system. It provides all of the
necessary communication between the camera and the LINK to trigger the flash unit. While it is camera
specific for usage of TTL and HSS, the HUB will function as a standard trigger similar to our CyberSync
Trigger Transmitter and can be used with any camera brand.
The frequency (FREQ) ranges from 1 - 16.
To set the frequency turn the ROTARY
WHEEL until FREQ appears on the
display. Press in on the ROTARY WHEEL
to enter the FREQ section. Turn the
ROTARY WHEEL until your desired
frequency appears. Press in on the
ROTARY WHEEL to confirm your
selection.
SETTING THE FREQUENCY
HUB REMOTE
Press in on the rotary wheel, located on
the left side of the HUB. This will send a
test fire to any flash units that are on the
same frequency.
SENDING A TEST FIRE
Press and hold the POWER button,
located on the right side of the
HUB, for two seconds.
POWERING THE HUB ON / OFF
POWER BUTTON
Slide the bottom of the HUB onto
your camera’s hot shoe. Turn the
locking wheel clockwise to lock
the HUB on to your camera.
ATTACHING THE HUB TO YOUR CAMERA
LOCKING BOTTOM
HOT SHOE
(CAMERA BRAND SPECIFIC)
ROTARY
WHEEL
CHARGING THE HUB
CHARGING
PORT
To charge the HUB plug the USB-C side
of the included charging cable directly
into the HUB. Then plug the USB-A side
into a wall outlet connector.
Using the ROTARY WHEEL, scroll three
times so that BRIGHTNESS appears
on the display. Then, press in on the
ROTARY WHEEL. To adjust the
brightness scroll using the ROTARY
WHEEL until you have reached your
desired brightness level. Press in on
the ROTARY WHEEL to safe your setting.
CHANGING THE DISPLAY BRIGHTNESS
ROTARY
WHEEL
REAR DISPLAY
BATTERY INDICATOR
BLUETOOTH
HSS / TTL INDICATOR
FREQUENCY
ROTARY
WHEEL
To set the HUB into TTL mode, turn the ROTARY WHEEL until TTL appears on the display. Press in on the
ROTARY WHEEL to enter the TTL section. Turn the ROTARY WHEEL to toggle between ON and OFF.
Press in on the ROTARY WHEEL to confirm your selection.
TTL MODE
The HUB will enter HSS mode automatically when your camera is set above it’s max sync speed.
The HUB will also superseed any settings found on the LINK. For example, if the LINK is set to COLOR
MODE but you are now shooting above your camera’s max sync speed, the HUB will then adjust the LINK
and place it into HSS MODE.
HSS MODE
1110
By default, BLUETOOTH is ON when the HUB is first activated.
To turn BLUETOOTH ON or OFF, turn the ROTARY WHEEL until BLUETOOTH
appears on the display. Press in on the ROTARY WHEEL to enter the
BLUETOOTH section. Turn the ROTARY WHEEL to toggle between ON and OFF.
Press in on the ROTARY WHEEL to confirm your selection.
BLUETOOTH
(CAMERA BRAND SPECIFIC)