Warranty

ManualsBrandsPatton ManualsHeating, Ventilation, and Air Conditioning1500-Watt Utility Space Heater

PLEASE READ AND SAVE THESE

IMPORTANT SAFETY INSTRUCTIONS

FEATURES - OPERATIONS

CLEANING/MAINTENANCE

Always unplug the heater before cleaning and allow the

heater to cool down.

1. Clean the unit with a soft cloth moistened with a mild

soap and water solution.

2. NEVER use abrasive or flammable solvents to clean

the unit.

3. After cleaning, be sure to completely dry the unit

with a cloth or towel.

4. Store heater in a cool, dry location.

5. It is recommended that you store the unit in its

original carton.

AUTO SAFETY SHUT-OFF WITH INSTANT

TIP-OVER PROTECTION

This heater is equipped with a Total Safety System with

tip-over protection that will shut-off the heater in an

overheat situation.

Tip-over Shut-off:

When the unit is accidentally knocked over, it will shut

off. To reset, simply place the heater in an upright

position on a level surface.

Overheat Shut-off:

When a potential overheat temperature is reached, the

system will automatically shut the heater off. Make sure

heater is clear of all obstructions. It can only resume

operation when the user resets the unit.

To Reset the Heater:

1. Unplug the heater and wait 30 minutes for the unit

to cool down.

2. After the 30 minutes, plug the unit in again and

operate normally.

3. Place heater on firm level surface.

TROUBLESHOOTING

If your heater fails to operate:

• Make sure the electrical outlet or circuit breaker is

working.

• Check for obstructions. If you find an obstruction turn

the heater OFF, and UNPLUG THE UNIT. Carefully

remove the obstruction and follow the reset

instructions.

• The thermostat might be set too low. Turn the

Thermostat Control clockwise until the heater restarts.

• Make sure the Selector is in Low (1) or High (2)

setting.

Please DO NOT attempt to open or repair the

heater.

TECHNICAL SPECIFICATIONS

• Amps: 12.5

• Wattage: 1500W (+5% -10%)

• Working voltage: 120V AC/60Hz

ASSEMBLY INSTRUCTIONS

Carefully remove your heater and all parts from the box.

Ensure all parts are in the package. It is recommended

save carton for off-season storage.

This package includes:

1 - Heater

1 - Carry Handle

2 - Screws

Handle Assembly:

1. Place the heater in upright position.

2. Use the provided screws to attach the carry handle on

top of the heater housing (See Figure 1).

3. Use screw driver to tighten the screws firmly. Please

ensure that screws are not overtightened.

NOTE: THIS UNIT IS FOR FLOOR USE ONLY.

OPERATING INSTRUCTIONS

1. Place heater on firm level surface.

2. Avoid overloading your circuit by not using other high

wattage appliances in the same outlet. At 1500

Watts, this unit draws 12.5 Amps.

Mode Settings

1. To start the heater operation, turn the Thermostat

Control clockwise all the way to the highest.

2. Switch the Selector to your desired heat settings:

1 - Low Heat

The heater will run continuously at 1350W.

2 - High Heat

The heater will run continuously at 1500W.

3. The Power Light will remain lit during operation.

Thermostat Control

1. You need to turn the Thermostat Control clockwise to

the highest position to start heater. Allow heater to

operate and warm up the room.

2. When the desired temperature/comfort level is

reached, lower the temperature setting by turning the

Thermostat Control counter-clockwise until the heater

stops operating.

3. The thermostat will now automatically maintain the

pre-set temperature level by turning the heater ON

and OFF.

NOTE: It is normal for the heater to cycle ON and OFF as

it maintains the preset temperature. To prevent the unit

from cycling, you need to raise the temperature setting.

When using electrical appliances, basic safety precautions

should always be followed to reduce the risk of fire, electric

shock, and injury to persons, including the following:

1. Read all instructions before using the appliance.

2. To avoid fire or shock hazard, plug the appliance

directly into a 120V AC electrical outlet.

3. The heater is hot when in use. To avoid burns, DO

NOT let bare skin touch hot surfaces. If provided, use

handles when moving this heater. Keep combustible

materials, such as furniture, pillows, bedding, papers,

clothes, and curtains at least 3 ft (0.9 m) from the

front of the heater and keep them away from the

sides and rear.

4. DO NOT run cord under carpeting. DO NOT cover

cord with throw rugs, runners, or the like. Arrange

cord away from traffic area and where it will not be

tripped over.

5. This heater is not intended for use in bathrooms,

laundry areas and similar indoor location. NEVER

locate heater where it may fall into a bathtub or

other water container.

6. Extreme caution is necessary when any heater is

used by, or near children or invalids, and whenever

the heater is left operating and unattended.

7. Always unplug the heater when not in use.

8. When unplugging, be sure to pull by the plug and

not the cord.

9. DO NOT insert or allow foreign objects to enter any

ventilation or exhaust opening as this may cause an

electric shock or fire, or damage the heater.

10. DO NOT operate heater with a damaged cord or plug,

or after the heater malfunctions, has been dropped

or damaged in any manner. Return appliance to

manufacturer for examination, electrical or

mechanical adjustment, or repair.

11. A heater has hot and arcing or sparking parts inside.

DO NOT use it in areas where gasoline, paint, or

flammable liquids are used or stored.

12. Use appliance only for intended household use as

described in this manual. Any other use not

recommended by the manufacturer may cause fire,

electric shock, or injury to persons. The use of

attachments not recommended or sold by the

manufacturer may cause hazards.

13. DO NOT use outdoors.

14. To prevent a possible fire, DO NOT block air intakes or

exhaust in any manner. DO NOT use on soft surfaces,

like a bed, where openings may become blocked.

15. To disconnect heater, turn controls to OFF, then

remove plug from outlet.

16. Avoid the use of an extension cord because the

extension cord may overheat and cause a risk of fire.

However, if you have to use an extension cord, the

cord shall be No. 14 AWG minimum size and rated

not less than 1875 watts.

17. If the heater will not operate, see specific instructions

on Auto Safety Shut-off.

18. DO NOT attempt to repair or adjust any electrical or

mechanical functions on this unit. Doing so will void

your warranty. The inside of the unit contains no user

serviceable parts. All servicing should be performed

by qualified personnel only.

19. Discontinue use if plug or outlet is hot. It is

recommended that the outlet be replaced if plug or

outlet is hot to touch.

PLEASE READ AND SAVE

THESE IMPORTANT

SAFETY INSTRUCTIONS

CLEANING / MAINTENANCE

TROUBLESHOOTING

THIS APPLIANCE HAS A POLARIZED PLUG (one blade is wider than the

other). To reduce the risk of electric shock, this plug is intended to fit in a

polarized outlet only one way. If the plug does not fit fully in the outlet,

reverse the plug. If it still does not fit, contact a qualified electrician to

install the proper outlet.

DO NOT ATTEMPT TO MODIFY THIS PLUG OR DEFEAT THIS

SAFETY FEATURE IN ANY WAY.

If you have any questions regarding your product or

would like to learn more about other Patton

products, please contact our Consumer Service

Department at 1-800-333-1930 or visit our website

at www.pattonproducts.com.

Figure 1

Figure 2

A. Selector/Power Light

B. Thermostat Control

C. Protective Front Guards

D. Carry Handle

Figure 3

CONTROL PANEL CLOSE-UP

A. Selector/

Power Light

B. Thermostat

Control

PUH680-U_09EM1.indd 2PUH680-U_09EM1.indd 2 3/16/09 9:01:14 AM3/16/09 9:01:14 AM