- Patton Leased-Line Extenders over IP Getting Started Guide

Installing the SmartNode extender 28
Model 2292 & 2294 Series Getting Started Guide 3 • Hardware installation
Installing the Ethernet cable
The SmartNode 2292 Series has automatic MDX (auto-cross-over) detection and configuration on the Ether-
net ports. Any of the two ports can be connected to a host or hub/switch with a straight-through wired cable
(see figure 10 on page 28). Ethernet devices (10Base-T or 100Base-T) are connected to the SmartNode’s Ether-
net ports (see table 6 for port pin-out listing) via a cable terminated with RJ-45 plugs. Because the SmartNode
2294 Series does not have the MDX feature, a cross-over cable is required when connecting SmartNode 2294
Series devices to a host (see figure 11 on page 29).
Note Pins not listed are not used.
Figure 10. Connecting a SmartNode 2294 Series device to a hub
Table 6. Ethernet 10/100Base-T (RJ-45) port pin-outs (SmartNode 2294 Series)
Pin Signal
1 TX+
2 TX-
3 RX+
6 RX-
Hub
Straight-through cable
RJ-45, male
Tx+
Tx-
Rx+
Rx-
1
2
3
6
RJ-45, male
1 Rx+
2 Rx-
3 Tx+
6 Tx-
, 1.25A
Reset
Ports
ETH 0/1 ETH 0/0