- Patton Leased-Line Extenders over IP Getting Started Guide

Installing the SmartNode extender 26
Model 2292 & 2294 Series Getting Started Guide 3 • Hardware installation
Installing an interface cable on the extender’s voice ports
The SmartNode extender comes with at least two voice ports (see figure 6) located on the back of the extender.
The voice ports are connected to analog devices via cables (see figure 7) terminated with RJ-11 connectors (see
figure 9 and table 5 on page 27 for pin-out information).
Figure 6. Rear view showing location of Ethernet connectors and voice ports (SmartNode 2294 shown)
Figure 7. Analog connection
, 1.25A
Reset
Ports
ETH 0/1 ETH 0/0
Ethernet connectors
Voice ports
, 1.25A
Reset
Ports
ETH 0/1
ETH 0/0
RJ-11, male RJ-11, male
, 1.25A
Reset
Ports
ETH 0/1 ETH 0/0