- Patton VoIP SoHo Router Getting Started Guide
Table Of Contents
- Summary Table of Contents
- Table of Contents
- List of Figures
- List of Tables
- About this guide
- Chapter 1 General information
- Chapter 2 SmartLink installation
- Chapter 3 Home
- Chapter 4 Network—WAN
- Status
- Settings
- QoS (Quality of Service)
- ToS/DiffServ
- IPSec Configuration
- Select Tunnel to view/modify
- Enable tunnel 1
- Remote IP Address range
- Remote security gateway
- Security Mode
- Outbound AH SPI (DEC)
- Outbound AH Authentication Algorithm
- Outbound AH Authentication Key (HEX)
- Outbound ESP SPI (DEC)
- Outbound ESP Encryption Algorithm
- Outbound ESP Authentication Algorithm
- Outbound ESP Encryption Key (HEX)
- Outbound ESP Authentication Key (HEX)
- Inbound AH SPI (DEC)
- Inbound AH Authentication Algorithm
- Inbound AH Authentication Key (HEX)
- Inbound ESP SPI (DEC)
- Inbound ESP Encryption Algorithm
- Inbound ESP Authentication Algorithm
- Inbound ESP Encryption Key (HEX)
- Inbound ESP Authentication Key (HEX)
- Saving your work
- Chapter 5 Network—LAN
- Chapter 6 Telephony
- VoIP Status
- SIP
- Audio/CODEC Configuration
- Phone 1 & Phone 2
- Speed Dial
- Chapter 7 System
- Set Security Password
- Configuration
- Manual Upgrade
- Auto Upgrade
- Localization
- Call Progress Tones
- Distinctive Ring Setting 1–8
- Supplementary Service Keys
- Cfwd All Serv Act Keys
- Cfwd Busy Act Keys
- Cfwd Sel Act Keys
- Call Waiting Act Keys
- Incoming Call Block Act Keys
- Block ANC Act Keys
- Dist Ring Act Keys
- Warm Line Act Keys
- DND Act Keys
- IP Dialing Act Keys
- Speed Dialing Act Keys
- Income CID Act Keys
- Self CID Block Keys
- Deact Keys
- Call Return Keys
- W–L Num Keys
- SP–D Num Keys
- IP–D Num Keys
- CFWALL Num Keys
- Call Hold Keys
- Call Alternative Keys
- Conference Keys
- Conference Drop Keys
- Transfer Keys
- Control Timer Values
- Ring Setting
- Miscellaneous
- FXS Port Polarity Configuration
- Saving your work
- SNMP Configuration
- Reload
- Chapter 8 Documentation
- Chapter 9 Logout
- Chapter 10 Contacting Patton for assistance
- Appendix A Compliance information
- Appendix B Specifications
- Appendix C Dial plans
- Appendix D Calling Features
- Appendix E Ring Cadence Configuration
Manual Upgrade 69
SmartLink 4020 Getting Started Guide 7 • System
Manual Upgrade
For both HTTP and TFTP methods, the device will reboot itself into the downloader mode if the main appli-
cation is executing, and proceed with the ROM file download and permanent write of the application to the
device’s flash memory. After the download is completed, the download status page will be displayed.
Figure 41. Manual Upgrade window
Auto Upgrade
Figure 42. AutoUpgrade window
Enable Auto Upgrade
Enable or disable auto upgrade—If enabled, the SmartLink 4020 will automatically check the upgrade server
for new system firmware and software upon reload or power cycle.