- Patton VoIP SoHo Router Getting Started Guide
Table Of Contents
- Summary Table of Contents
- Table of Contents
- List of Figures
- List of Tables
- About this guide
- Chapter 1 General information
- Chapter 2 SmartLink installation
- Chapter 3 Home
- Chapter 4 Network—WAN
- Status
- Settings
- QoS (Quality of Service)
- ToS/DiffServ
- IPSec Configuration
- Select Tunnel to view/modify
- Enable tunnel 1
- Remote IP Address range
- Remote security gateway
- Security Mode
- Outbound AH SPI (DEC)
- Outbound AH Authentication Algorithm
- Outbound AH Authentication Key (HEX)
- Outbound ESP SPI (DEC)
- Outbound ESP Encryption Algorithm
- Outbound ESP Authentication Algorithm
- Outbound ESP Encryption Key (HEX)
- Outbound ESP Authentication Key (HEX)
- Inbound AH SPI (DEC)
- Inbound AH Authentication Algorithm
- Inbound AH Authentication Key (HEX)
- Inbound ESP SPI (DEC)
- Inbound ESP Encryption Algorithm
- Inbound ESP Authentication Algorithm
- Inbound ESP Encryption Key (HEX)
- Inbound ESP Authentication Key (HEX)
- Saving your work
- Chapter 5 Network—LAN
- Chapter 6 Telephony
- VoIP Status
- SIP
- Audio/CODEC Configuration
- Phone 1 & Phone 2
- Speed Dial
- Chapter 7 System
- Set Security Password
- Configuration
- Manual Upgrade
- Auto Upgrade
- Localization
- Call Progress Tones
- Distinctive Ring Setting 1–8
- Supplementary Service Keys
- Cfwd All Serv Act Keys
- Cfwd Busy Act Keys
- Cfwd Sel Act Keys
- Call Waiting Act Keys
- Incoming Call Block Act Keys
- Block ANC Act Keys
- Dist Ring Act Keys
- Warm Line Act Keys
- DND Act Keys
- IP Dialing Act Keys
- Speed Dialing Act Keys
- Income CID Act Keys
- Self CID Block Keys
- Deact Keys
- Call Return Keys
- W–L Num Keys
- SP–D Num Keys
- IP–D Num Keys
- CFWALL Num Keys
- Call Hold Keys
- Call Alternative Keys
- Conference Keys
- Conference Drop Keys
- Transfer Keys
- Control Timer Values
- Ring Setting
- Miscellaneous
- FXS Port Polarity Configuration
- Saving your work
- SNMP Configuration
- Reload
- Chapter 8 Documentation
- Chapter 9 Logout
- Chapter 10 Contacting Patton for assistance
- Appendix A Compliance information
- Appendix B Specifications
- Appendix C Dial plans
- Appendix D Calling Features
- Appendix E Ring Cadence Configuration
System information 27
SmartLink 4020 Getting Started Guide 3 • Home
System information
Figure 4. SmartLink VoIP download and configuration Home page
System Uptime
Shows how long the SmartLink has been operating since the last time it was reset.
LAN IP Address
The IP address of your LAN.
MAC address
The media access control (MAC) address of the LAN Ethernet interface in the SmartLink.
Application Version
The SmartLink firmware version number.
Config Date
The date of the configuration file that was downloaded from an auto-upgrade server.
Security
Indicates that the SmartLink utility has been secured with a password. To configure a password, see section “Set
Security Password” on page 67.
Application Code Version
Shows the application code version being used.
Download Code Version
Shows the download code version being used.