- Patton Electronics ADSL2/2+ Triple-Play Access IPDSLAM Module Getting Started Guide

Hardware Installation 16

Model 3101RC Getting Started Guide 2 • Hardware Installation

Hardware Installation

The hardware installation for the Model 3101RC is simple and without complex hardware setting. However, it

should be installed following the standard installation procedures. During installation, basic safety precautions

should always be taken, especially, be sure to wear an antistatic wrist strap to prevent static electricity from

damaging the system and injury to the operator. Handle electronic components as little as possible.

Connecting the ADSLx interfaces

The Model 3101RC supports 24/48 ADSL/2/2+ ports. There are two RJ-21 50-pin female connectors on the

front panel of the 3101RC TM card. One connector is for DSL ports 1~24; the other is for DSL ports 25~48.

When installing, just plug the end of a cable with the RJ-21 50-pin male connector into the DSL interface

female connector on the TM card. The other side of the cable is generally tied to the MDF.

The pin assignment of ADSLx interface is illustrated below:

Figure 3. Pin Assignment of DSL Interfaces

Note Tip 1 is for Port 1 in regard to the connector for 1~24 ports, or Port

25 in regard to the connector for 25~48 ports.

125

2650

26 27 28 29 30 31 32 33 - 43 44 45 46 47 48 49 50

1 2 3 4 5 6 7 8 - 18 19 20 21 22 23 24 25

Tip

Tip Tip Tip Tip Tip Tip Tip Tip Tip Tip Tip Tip Tip Tip

1 2 3 4 5 6 7 8 - 18 19 20 21 22 23 24 25

-X

Ring Ring Ring Ring Ring Ring Ring Ring Ring Ring Ring Ring Ring Ring Ring