User Guide
pppoe set transport 131
Model 3231 CLI Reference Guide 13 • PPPoE Commands
specificroute disabled Create a default route to the subnet
at the remote end of the PPP link.
enabled Allow the created route to apply to
packets for the subnet at the remote
end of the PPP link.
subnetmask <mask> Set the subnet mask used for the
local IP interface connected to the
PPP transport.
theylogin chap Set CHAP (Challenge Handshake
Authentication Protocol) for the
authentication method remote PPP
clients must use to dialin to the
server.
none No authentication method is used.
pap Set PAP (Password Authentication
Protocol) for the authentication
method remote PPP clients must use
to dialin to the server.
username <username> Set a dial-out username on a named
transport.
vci <vci> Set the Virtual Circuit Identifier
(Applies only to existing PVC trans-
ports).
vpi <vpi> Set the Virtual Path Identifier
(Applies only to existing PVC trans-
ports).
welogin auto The authentication protocol used by
the remote PPP server is discovered
and used.
chap Set CHAP (Challenge Handshake
Authentication Protocol); Server
sends an authentication request to
the remote user dialing in.
none No authentication method is used.
pap Set PAP (Password Authentication
Protocol); Server sends an authenti-
cation request to the remote user
dialing in.
Table 94. pppoe set transport
Command Explanation