User Guide

pppoe set transport 129
Model 3231 CLI Reference Guide 13 • PPPoE Commands
eth <port> Set the ethernet port that an existing
PPPoE transport uses to transport
PPPoE data.
givedns client disabled IPCP cannot request a DNS server IP
address and then give the address
to the DNS client.
enabled Allow IPCP to request a DNS server
IP address and then give the address
to the DNS client.
relay disabled IPCP cannot request a DNS server IP
address and then give the address
to DNS relay.
enabled Allow IPCP to request a DNS server
IP address and then give the address
to DNS relay.
headers hdlc disabled Do not allow packets that have
HDLC headers to be transmit-
ted/received.
enabled Allow packets that have HDLC head-
ers to be transmitted/received.
llc disabled Do not allow packets that have LLC
headers to be transmitted/received.
enabled Allow packets that have LLC headers
to be transmitted/received.
idletimeout <idletimeout> Set an idle time out for your LAN
connection.
interface <iface> Set the PPP interface for an existing
PPPoE transport.
lcpechoevery <lcpechoevery> Tell a specified PPP transport to send
an LCP (Link Control Protocol) echo
request frame at specified intervals
(in seconds).
lcpmaxconf <lcpmaxconf> Set the LCP maximum configure num-
ber for an existing transport.
lcpmaxfail <lcpmaxfail> Set the LCP maximum fail number for
an existing transport.
lcpmaxterm <lcpmaxterm> Set the LCP maximum terminate num-
ber for an existing transport.
localip <ipaddress> Only applies to dialin SVC or PVC
transports that provide the server-
end of a connection.
mbs <mbs> Set the maximum burst size for
PPPoE transport (Applies only to
existing PVC transports).
Table 94. pppoe set transport
Command Explanation