User Guide

pppoa set transport 119
Model 3231 CLI Reference Guide 12 • PPPoA Commands
headers hdlc disabled Do not allow packets that have HDLC headers to
be transmitted/received.
enabled Allow packets that have HDLC headers to be
transmitted/received.
llc disabled Do not allow packets that have LLC headers to be
transmitted/received.
enabled Allow packets that have LLC headers to be trans-
mitted/received.
idletimeout <idletimeout> Set an idle time out for your LAN connection.
interface <iface> Set the PPP interface for an existing PPPoA trans-
port.
lcpechoevery <lcpechoevery> Tell a specified PPP transport to send an LCP (Link
Control Protocol) echo request frame at specified
intervals (in seconds).
lcpmaxconf <lcpmaxconf> Set the LCP maximum configure number for an
existing transport.
lcpmaxfail <lcpmaxfail> Set the LCP maximum fail number for an existing
transport.
lcpmaxterm <lcpmaxterm> Set the LCP maximum terminate number for an
existing transport.
localip <ipaddress> Only applies to dialin SVC or PVC transports that
provide the server-end of a connection.
mbs <mbs> Set the maximum burst size for PPPoA transport
(Applies only to existing PVC transports).
mcr <mcr> Set the minimum cell rate for an existing PPPoA
transport (Applies only to existing PVC trans-
ports).
mru <mru> Set the interface’s maximum receive unit (MRU)
(in bytes).
password <password> Set a dial-out password on a named transport.
pcr <pcr> Set the peak cell rate for an existing PPPoA trans-
port (Applies only to existing PVC transports).
port <port> Set the port that an existing transport uses to
transport PPPoA data (Applies only to existing
PVC transports).
pvc <port> <vpi><vci> Set PVC (Permanent Virtual Circuit) for PPPoA
data.
Table 88. pppoa set transport
Command Explanation