USER M A N UA L MODEL IM 1/I Ethernet Bridge Module Part# 07MIM1I-D Doc# 090101UD Revised 7/29/99 An ISO-9001 Certified Company SALES OFFICE (301) 975-1000 TECHNICAL SUPPORT (301) 975-1007 http://www.patton.
1.0 WARRANTY INFORMATION Patton Electronics warrants all Model IM1/I components to be free from defects, and will—at our option—repair or replace the product should it fail within one year from the first date of shipment. This warranty is limited to defects in workmanship or materials, and does not cover customer damage, abuse or unauthorized modification. If this product fails or does not perform as warranted, your sole recourse shall be repair or replacement as described above.
2.0 GENERAL INFORMATION 2.3 TYPICAL APPLICATION Thank you for your purchase of this Patton Electronics product. This product has been thoroughly inspected and tested and is warranted for One Year parts and labor. If any questions or problems arise during installation or use of this product, please do not hesitate to contact us at: (301) 975-1007, http://www.patton.com; support@patton.com. The Model IM1/I QuickConnect™ is designed to plug directly into the rear of a Patton Electronics baseband modem (i.e.
3.0 CONFIGURATION 4.0 INSTALLATION The Model IM1/I module plugs into Patton’s fiber and copper baseband modems to provide Ethernet LAN extension. The IM1/I has no switches or jumpers and does not need to be configured. However, factors such as ty type of medium, throughput across the link and clocking mode must be determined by the settings of the baseband modems. Please refer to your baseband modem (i.e. 1092A, 1093, 1095, 1185, etc) to make the following settings.
3.1.2 Installing the New QuickConnect™ Module 4.2 CONNECTING TO THE 10BASE-T ETHERNET PORT 1) Make sure the power switch on the base unit is off. Leave the power cord plugged into a grounded outlet to keep the unit grounded. The RJ-45 Ethernet port on Model IM1/I is designed to connect directly to a 10BaseT network. Figure 3, below, shows the 10BaseT RJ-45 port pin description. You may make connections up to 330 feet using Type 4 or 5 cable.
5.0 OPERAT I O N 4.3 CONNECTION TO THE LINE INTERFACE MEDIA Instructions for connecting the line interface media (twisted pair , or fiber optic cable) are contained within the base unit user manual. Please refer to the base unit manual for connection details. Once the Model IM1/1 is installed, it should operate transparently. This sections describes power-up, general operating instructions, and the LED status monitors. 5.
APPENDIX A 5.3 LED STATUS MONITORS The Model IM1/I features two LEDs that monitor general operating status and the 10Base-T twisted pair link integrity. Figure 4 (below) shows the LEDs located directly beneath the RJ-45 jack. Following Figure 4 is a description of each LEDs function. Quik-Connect Interface Module Link LED Status LED Interface Port PATTON MODEL IM1/I SPECIFICATIONS LAN Connection: RJ-45, 10Base-T, 802.
APPENDIX B IM1/I INTERFACE PIN ASSIGNMENT Dear Valued Customer, Thank you for purchasing Patton Electronics products! We do appreciate your business. I trust that you find this user manual helpful.
