- Patton Electronics Network Cables User Manual

4 Model 3088A Series Quick Start Guide
Figure 2. Model 3088A/CA front panel
2.3 Power up indication
Verify that the Power LED (see figure 2) illuminates and remains lit.
3.0 Connect the G.SHDSL port
1. Obtain single-twisted-pair cable with an RJ-45 plug connector at each end.
2. Plug one end of the cable into the RJ-45 socket (labelled DSL) on the OnSite CPE.
— If you are connecting to a DSL service, plug the other end of the cable into the RJ-45 wall
socket that provides your G.SHDSL service.
— If connecting to another OnSite, verify the other end of the cable is connected to the DSL port
on other OnSite and the DSL port is correctly configured.
3. When a DSL link is established, the front-panel DSL LED will turn on.
4.0 Connect the serial port
Your OnSite comes with one of the following serial WAN ports for connection to an CPE:
• RS-232 (DB-25F)—Model 3088A/A
• V.35 (DB-25F)—Model 3088A/CA
• X.21 (DB-15)—Model 3088A/D
• E1 (120-Ohm RJ-48C and dual 75-Ohm BNC connectors)—Model 3088A/K
DSL
Terminal
TM / ERR
Power
Activity
Link