- Patton Electronics USER MANUAL High Speed, 2-Wire/4-Wire, Sync & Async Short Range Modem 1092A

APPENDIX DAPPENDIX D

PATTON ELECTRONICSMODEL 1092A

CONTROL PORT PIN ASSIGNMENT

The 1092A control port is an 8 position connector, compliant with

EIA/TIA-561.

Pin Function RJ45 Pin No.

Ground 4

Receive data (to DTE) 5

Transmit data (from DTE) 6

APPENDIX EAPPENDIX E

PATTON ELECTRONICS MODEL 1092A PATTON ELECTRONICS MODEL 1092A

QUICK START GUIDEQUICK START GUIDE

1) To perform a hardware reset, turn the power off and set

configuration switch (S1-6 and 7 “OFF").

2) Turn on the power for 5 or 10 seconds. Turn the power OFF and

re-configure the model 1092A using the following configuration.

One unit must be set as Master the other unit as Slave.

MASTER UNIT SETTINGS

S1-1 "ON"

S1-2 "OFF"

S1-3 "ON"

S1-4 and 5 "OFF"

S1-6 and 7 "ON"

S1-8 "ON"

S2-1, 2, and 3 "OFF"

S2-4 "ON" (4-wire operation) "OFF" (2-wire operation)

S2-5 "OFF"

S2-6, 7 and 8 "ON"

SLAVE UNIT SETTINGS

S1-1 "ON"

S1-2 "OFF"

S1-3 "ON"

S1-4 and 5 "OFF"

S1-6 "ON"

S1-7 "OFF"

S1-8 "ON"

Switch S2 settings are the same as the MASTER UNIT.

3) Connect the twisted pair circuit between the model 1092A's, turn

on the power, after 10 to 15 seconds the NS (no signal)- LED

will go off and the CD (carrier detect) LED will turn GREEN.

4) Perform a LOCAL LINELOOP-BACK test using the 511/511E

test switch (See section 5.3.1).

5) Approximately 45 seconds after the units link up, perform a

REMOTE DIGITALLOOP-BACK test using the 511/511E test

switch. (See section 5.3.2).

Patton Electronics Company