Certifications 2

SDS No.: 43189 V004.0
Pattex Powerkleber Stabilit Express, Härter
Page 6 of 13
Derived No-Effect Level (DNEL):
Name on list
Application
Area
Route of
Exposure
Health Effect
Exposure
Time
Value
Remarks
Methyl methacrylate
80-62-6
Workers
dermal
Acute/short term
exposure - local
effects
1,5 mg/cm2
Methyl methacrylate
80-62-6
Workers
dermal
Long term
exposure -
systemic effects
13,67 mg/kg
Methyl methacrylate
80-62-6
Workers
Inhalation
Long term
exposure -
systemic effects
208 mg/m3
Methyl methacrylate
80-62-6
Workers
dermal
Long term
exposure - local
effects
1,5 mg/cm2
Methyl methacrylate
80-62-6
Workers
Inhalation
Long term
exposure - local
effects
208 mg/m3
Methyl methacrylate
80-62-6
General
population
dermal
Acute/short term
exposure - local
effects
1,5 mg/cm2
Methyl methacrylate
80-62-6
General
population
dermal
Long term
exposure -
systemic effects
8,2 mg/kg
Methyl methacrylate
80-62-6
General
population
Inhalation
Long term
exposure -
systemic effects
74,3 mg/m3
Methyl methacrylate
80-62-6
General
population
dermal
Long term
exposure - local
effects
1,5 mg/cm2
Methyl methacrylate
80-62-6
General
population
Inhalation
Long term
exposure - local
effects
105 mg/m3
Biological Exposure Indices:
None
8.2. Exposure controls:
Respiratory protection:
Suitable breathing mask when there is inadequate ventilation.
Combination filter: ABEKP (EN 14387)
This recommendation should be matched to local conditions.
Hand protection:
Recommended are gloves made from Nitril rubber ( Material thickness >0,1 mm, Perforation time < 30s).Gloves should be
replaced after each short time contact or contamination. Available at laboratory specialized trade or at pharmacies / chemist's
shops.
In the case of longer contact protective gloves made from nitrile rubber are recommended according to EN 374.
material thickness > 0.4 mm
Perforation time > 10 minutes
In the case of longer and repeated contact please note that in practice the penetration times may be considerably shorter than
those determined according to EN 374. The protective gloves must always be checked for their suitability for use at the specific
workplace (e.g. mechanical and thermal stress, product compatibility, antistatic effects, etc.). The gloves must be replaced
immediately at the first signs of wear and tear. The information provided by the manufacturers and given in the relevant trade
association regulations for industrial safety must always be observed. We recommend that a hand care plan is drawn up in
cooperation with a glove manufacturer and the trade association in accordance with the local operating conditions.
Eye protection:
Goggles which can be tightly sealed.
Protective eye equipment should conform to EN166.
Skin protection:
Suitable protective clothing
Protective clothing should conform to EN 14605 for liquid splashes or to EN 13982 for dusts.