Certifications 2

SDS No.: 43188 V004.0
Pattex Powerkleber Stabilit Express, Härter
Page 5 of 11
Predicted No-Effect Concentration (PNEC):
Name on list
Environmental
Compartment
Exposure
period
Value
Remarks
mg/l
ppm
mg/kg
others
Dibenzoyl peroxide
94-36-0
aqua
(freshwater)
0,000602
mg/l
Dibenzoyl peroxide
94-36-0
aqua (marine
water)
0,00006
mg/l
Dibenzoyl peroxide
94-36-0
aqua
(intermittent
releases)
0,000602
mg/l
Dibenzoyl peroxide
94-36-0
sewage
treatment plant
(STP)
0,35 mg/l
Dibenzoyl peroxide
94-36-0
sediment
(freshwater)
0,338
mg/kg
Dibenzoyl peroxide
94-36-0
soil
0,0758
mg/kg
Dibenzoyl peroxide
94-36-0
oral
6,67 mg/kg
Derived No-Effect Level (DNEL):
Name on list
Application
Area
Route of
Exposure
Health Effect
Exposure
Time
Value
Remarks
Dibenzoyl peroxide
94-36-0
Workers
Inhalation
Long term
exposure -
systemic effects
11,75 mg/m3
Dibenzoyl peroxide
94-36-0
Workers
dermal
Long term
exposure -
systemic effects
6,6 mg/kg
Dibenzoyl peroxide
94-36-0
General
population
Inhalation
Long term
exposure -
systemic effects
2,9 mg/m3
Dibenzoyl peroxide
94-36-0
General
population
dermal
Long term
exposure -
systemic effects
3,3 mg/kg
Dibenzoyl peroxide
94-36-0
General
population
oral
Long term
exposure -
systemic effects
1,65 mg/kg
Biological Exposure Indices:
None
8.2. Exposure controls:
Respiratory protection:
In case of dust formation, we recommend wearing of appropriate respiratory protection equipment with particle filter P (EN
14387).
This recommendation should be matched to local conditions.
Hand protection:
Recommended are gloves made from Nitril rubber ( Material thickness >0,1 mm, Perforation time < 30s).Gloves should be
replaced after each short time contact or contamination. Available at laboratory specialized trade or at pharmacies / chemist's
shops.
In the case of longer contact protective gloves made from nitrile rubber are recommended according to EN 374.
material thickness > 0.4 mm
Perforation time > 10 minutes
In the case of longer and repeated contact please note that in practice the penetration times may be considerably shorter than
those determined according to EN 374. The protective gloves must always be checked for their suitability for use at the specific
workplace (e.g. mechanical and thermal stress, product compatibility, antistatic effects, etc.). The gloves must be replaced
immediately at the first signs of wear and tear. The information provided by the manufacturers and given in the relevant trade
association regulations for industrial safety must always be observed. We recommend that a hand care plan is drawn up in
cooperation with a glove manufacturer and the trade association in accordance with the local operating conditions.