Safety data sheet

MSDS-No.: 433400
V001.0
Pattex Haus & Bau Silicon - alle Farben
Page 8 of 15
systemic effects
Methanol
67-56-1
General
population
dermal
Acute/short term
exposure -
systemic effects
8 mg/kg
Methanol
67-56-1
General
population
oral
Long term
exposure -
systemic effects
8 mg/kg
Methanol
67-56-1
General
population
oral
Acute/short term
exposure -
systemic effects
8 mg/kg
Methanol
67-56-1
General
population
Dermal
Long term
exposure - local
effects
8 mg/kg
Biological Exposure Indices:
None
8.2. Exposure controls:
Respiratory protection:
Suitable breathing mask when there is inadequate ventilation.
Filter : AX (EN 14387)
This recommendation should be matched to local conditions.
Hand protection:
Recommended are gloves made from Nitril rubber ( Material thickness >0,1 mm, Perforation time < 30s).Gloves should be
replaced after each short time contact or contamination. Available at laboratory specialized trade or at pharmacies / chemist's
shops.
In the case of longer contact protective gloves made from nitrile rubber are recommended according to EN 374.
Perforation time > 30 minutes
material thickness > 0.4 mm
In the case of longer and repeated contact please note that in practice the penetration times may be considerably shorter than
those determined according to EN 374. The protective gloves must always be checked for their suitability for use at the specific
workplace (e.g. mechanical and thermal stress, product compatibility, antistatic effects, etc.). The gloves must be replaced
immediately at the first signs of wear and tear. The information provided by the manufacturers and given in the relevant trade
association regulations for industrial safety must always be observed. We recommend that a hand care plan is drawn up in
cooperation with a glove manufacturer and the trade association in accordance with the local operating conditions.
Eye protection:
Goggles which can be tightly sealed.
Protective eye equipment should conform to EN166.
Skin protection:
Suitable protective clothing
Protective clothing should conform to EN 14605 for liquid splashes or to EN 13982 for dusts.
Advices to personal protection equipment:
The information provided on personal protective equipment is for guidance purposes only. A full risk assessment should be
conducted prior to using this product to determine the appropriate personal protective equipment to suit local conditions.
Personal protective equipment should conform to the relevant EN standard.
SECTION 9: Physical and chemical properties
9.1. Information on basic physical and chemical properties
Appearance
paste
pasty
varied, according to
coloration
Odor
characteristic
Odour threshold
No data available / Not applicable
pH
No data available / Not applicable
Melting point
No data available / Not applicable
Solidification temperature
No data available / Not applicable
Initial boiling point
No data available / Not applicable
Flash point
117 °C (242.6 °F); no method