Certifications 2

SDS No.: 433400 V003.0
Pattex Haus & Bau Silicon - alle Farben
Page 12 of 24
systemic effects
Trimethoxyvinylsilane
2768-02-7
General
population
dermal
Long term
exposure -
systemic effects
7,8 mg/kg
Trimethoxyvinylsilane
2768-02-7
General
population
inhalation
Long term
exposure -
systemic effects
6,7 mg/m3
Trimethoxyvinylsilane
2768-02-7
General
population
oral
Long term
exposure -
systemic effects
0,3 mg/kg
Octamethylcyclotetrasiloxane
556-67-2
Workers
inhalation
Long term
exposure -
systemic effects
73 mg/m3
Octamethylcyclotetrasiloxane
556-67-2
Workers
inhalation
Long term
exposure - local
effects
73 mg/m3
Octamethylcyclotetrasiloxane
556-67-2
General
population
inhalation
Long term
exposure -
systemic effects
13 mg/m3
Octamethylcyclotetrasiloxane
556-67-2
General
population
inhalation
Long term
exposure - local
effects
13 mg/m3
Octamethylcyclotetrasiloxane
556-67-2
General
population
oral
Long term
exposure -
systemic effects
3,7 mg/kg
Octamethylcyclotetrasiloxane
556-67-2
Workers
inhalation
Acute/short term
exposure - local
effects
73 mg/m3
Octamethylcyclotetrasiloxane
556-67-2
Workers
inhalation
Acute/short term
exposure -
systemic effects
73 mg/m3
Octamethylcyclotetrasiloxane
556-67-2
General
population
inhalation
Acute/short term
exposure - local
effects
13 mg/m3
Octamethylcyclotetrasiloxane
556-67-2
General
population
inhalation
Acute/short term
exposure -
systemic effects
13 mg/m3
Octamethylcyclotetrasiloxane
556-67-2
General
population
oral
Acute/short term
exposure -
systemic effects
3,7 mg/kg
Biological Exposure Indices:
None
8.2. Exposure controls:
Respiratory protection:
The product should only be used at workplaces with intensive ventilation/extraction. If intensive ventilation/extraction is not
possible then self-contained independent respiratory protection should be worn.
Hand protection:
Recommended are gloves made from Nitril rubber ( Material thickness >0,1 mm, Perforation time < 30s).Gloves should be
replaced after each short time contact or contamination. Available at laboratory specialized trade or at pharmacies / chemist's
shops.
In the case of longer contact protective gloves made from nitrile rubber are recommended according to EN 374.
material thickness > 0.4 mm
Perforation time > 30 minutes
In the case of longer and repeated contact please note that in practice the penetration times may be considerably shorter than
those determined according to EN 374. The protective gloves must always be checked for their suitability for use at the specific
workplace (e.g. mechanical and thermal stress, product compatibility, antistatic effects, etc.). The gloves must be replaced
immediately at the first signs of wear and tear. The information provided by the manufacturers and given in the relevant trade
association regulations for industrial safety must always be observed. We recommend that a hand care plan is drawn up in
cooperation with a glove manufacturer and the trade association in accordance with the local operating conditions.
Eye protection:
Goggles which can be tightly sealed.
Protective eye equipment should conform to EN166.