Safety data sheet

MSDS-No.: 390433
V001.4
Pattex Gel Compact
Page 8 of 16
systemic effects
Rosin
8050-09-7
general
population
Dermal
Long term
exposure -
systemic effects
15 mg/kg bw/day
Rosin
8050-09-7
general
population
oral
Long term
exposure -
systemic effects
15 mg/kg bw/day
zinc oxide
1314-13-2
Workers
Inhalation
Long term
exposure -
systemic effects
5 mg/m3
zinc oxide
1314-13-2
Workers
Dermal
Long term
exposure -
systemic effects
83 mg/kg bw/day
zinc oxide
1314-13-2
general
population
Inhalation
Long term
exposure -
systemic effects
2,5 mg/m3
zinc oxide
1314-13-2
general
population
Dermal
Long term
exposure -
systemic effects
83 mg/kg bw/day
zinc oxide
1314-13-2
general
population
oral
Long term
exposure -
systemic effects
0,83 mg/kg bw/day
Biological Exposure Indices:
None
8.2. Exposure controls:
Respiratory protection:
Suitable breathing mask when there is inadequate ventilation.
Combination filter: ABEKP
This recommendation should be matched to local conditions.
Hand protection:
Recommended are gloves made from Nitril rubber ( Material thickness >0,1 mm, Perforation time < 30s).Gloves should be
replaced after each short time contact or contamination. Available at laboratory specialized trade or at pharmacies / chemist's
shops.
In the case of longer contact protective gloves made from nitrile rubber are recommended according to EN 374.
material thickness > 0.4 mm
Perforation time > 10 minutes
In the case of longer and repeated contact please note that in practice the penetration times may be considerably shorter than
those determined according to EN 374. The protective gloves must always be checked for their suitability for use at the specific
workplace (e.g. mechanical and thermal stress, product compatibility, antistatic effects, etc.). The gloves must be replaced
immediately at the first signs of wear and tear. The information provided by the manufacturers and given in the relevant trade
association regulations for industrial safety must always be observed. We recommend that a hand care plan is drawn up in
cooperation with a glove manufacturer and the trade association in accordance with the local operating conditions.
Eye protection:
Goggles which can be tightly sealed.
Skin protection:
Suitable protective clothing
SECTION 9: Physical and chemical properties
9.1. Information on basic physical and chemical properties
Appearance
gel
thixotropic
yellowish
Odor
of solvent
Odour threshold
No data available / Not applicable
pH
No data available / Not applicable
Initial boiling point
No data available / Not applicable
Flash point
< -20 °C (< -4 °F); DIN 51755 Closed cup flash point
Decomposition temperature
No data available / Not applicable