Certifications 2

SDS No.: 528149 V002.0
Pattex Repair 100% universal adhesive
Page 7 of 16
Biological Exposure Indices:
None
8.2. Exposure controls:
Respiratory protection:
Suitable breathing mask when there is inadequate ventilation.
Filter : AX (EN 14387)
This recommendation should be matched to local conditions.
Hand protection:
Recommended are gloves made from Nitril rubber ( Material thickness >0,1 mm, Perforation time < 30s).Gloves should be
replaced after each short time contact or contamination. Available at laboratory specialized trade or at pharmacies / chemist's
shops.
Eye protection:
Goggles which can be tightly sealed.
SECTION 9: Physical and chemical properties
9.1. Information on basic physical and chemical properties
Appearance
liquid
high viscosity
transparent
Odor
mild
Odour threshold
No data available / Not applicable
pH
No data available / Not applicable
Melting point
No data available / Not applicable
Solidification temperature
No data available / Not applicable
Initial boiling point
20 - 55 °C (68 - 131 °F)
Flash point
66,0 °C (150.8 °F); no method
Evaporation rate
No data available / Not applicable
Flammability
No data available / Not applicable
Explosive limits
No data available / Not applicable
Vapour pressure
No data available / Not applicable
Relative vapour density:
No data available / Not applicable
Density
(20 °C (68 °F))
1,10 - 1,16 g/cm3
Bulk density
No data available / Not applicable
Solubility
No data available / Not applicable
Solubility (qualitative)
(20 °C (68 °F); Solvent: Water)
Insoluble
Partition coefficient: n-octanol/water
No data available / Not applicable
Auto-ignition temperature
No data available / Not applicable
Decomposition temperature
No data available / Not applicable
Viscosity
(Brookfield; 40 °C (104 °F); Conc.: 10 ppm)
5.000 - 15.000 mPa.s
Viscosity (kinematic)
No data available / Not applicable
Explosive properties
No data available / Not applicable
Oxidising properties
No data available / Not applicable
9.2. Other information
No data available / Not applicable
SECTION 10: Stability and reactivity
10.1. Reactivity
None if used for intended purpose.
10.2. Chemical stability
Stable under recommended storage conditions.