Assembly Instructions

1. Secure the wall bracket and arm to the solid surface where you will hang the fan. A structurally secure or
solid wall/beam is best.
2. Secure the “U“ shaped yoke to the arm of the wall bracket. Use the 5/8” bolt and 5/8” nut supplied. Tighten
the nut onto the bolt using a 15/16” box end wrench and ratchet with a 5/16” socket. For clearance reasons,
the “U” shaped yoke must open down.
3. The fan head fits inside the “U” shaped yoke. Threaded studs on each side of the fan fit through the pre-
drilled holes on the yoke.
4. Use the included cord clips and self drilling screws to secure the power cord to the fan housing, yoke and
top side of the arm. The cord clips can also accommodate the power cord for the optional dock light. Zip
ties are included to bundle the power cords together and prevent them from getting caught on the end of
the arm when rotating the fan.
Note: DO NOT operate fan if the finger guards are damaged or missing.
The wall mount should be a solid
structure able to safely support the
weight of the fan. The fan should not be
at a height that will cause head injury
to employees. Ideally, the fan should
be mounted on the top corner of either
side of the dock door, allowing the fan
to blow down into the back of the truck.
IMPORTANT
TRUCK COOLER
ASSEMBLY
TC
pattersonfan.com
800.768.3985
THE AUTHORITY IN
AIR MOVEMENT