User Manual
The most important things to remember are that the fan must be hung at three points and that all materials used to
hang the fan must be rated for this type of rigging and workload. Below is what we consider to be the simplest method
of fan suspension.
1. Attach two eye bolts to holes in top front of fan. Attach third eye bolt to back rear hole in fan.
2. By means of a mechanical lift (cherry picker, scissor lift, etc.), get the factory assembled fan head to the point where
you plan to suspend it. You will need three lengths of chain, three connectors, hardware for chains and bolt cutters.
3. Secure two lengths of chain to the beam or girder number 1 about two times the distance apart that the fan will
hang down (see diagram). The third length of chain should be centered between the two front lengths of chain and
attached to beam number 2. Attach the chains to the beams using your preferred method.
4. Connect the lengths of chain to the eye bolts on the factory assembled fan head using the chain connectors.
5. Rough focus the fan on your target while on the mechanical lift.
6. Get a co-worker to stand at the target mark. Make sure the power is turned o. Have someone plug the fan in. Let
the fan run for approximately 30 seconds (to get up to speed and settle itself down). With someone on the floor,
someone at the fan, and someone at the power, focus the fan. DO NOT ATTEMPT TO ADJUST THE FAN WHILE
IT IS RUNNING!
7. Remove excess chain with bolt cutters.
Note: The two front chains should form an almost perfect 90° angle when attached to the fan. The distance of the fan
from the ceiling can throw this o, so adjust the chain spacing accordingly. The rear chain should be positioned so that
the fan leans slightly forward, about a 30° degree oset.
2 X
X
90°
90°
30°
Images not drawn to scale.
CHAIN SUSPENSION
ASSEMBLY
CS
pattersonfan.com
800.768.3985
THE AUTHORITY IN
AIR MOVEMENT