Assembly Instructions

2 X
X
90°
30°
Note: Due to continual product improvement,
items are subject to change without notice.
1. Facing outlet of fan, drill 2- 5/16” diameter holes (1/2” for 34” fan) one at 10 and one at 2:00 position in front ange. Facing the inlet side of
fan, drill 1- 5/16” diameter hole (1/2” for 24” fans) at the 6:00 position in rear ange. Holes should be drilled just behind the bead of the fan
housing.
2. Attach two eyebolts to holes in top front of fan. Attach third eyebolt to back rear hole in fan.
3. By means of a mechanical lift (cherry picker, scissor lift, etc.) get the factory assembled fan head to the point where you plan to suspend it.
You will need three lengths of chain, three connectors, hardware for chains and bolt cutters.
4. Secure two lengths of chain to the beam or girder number 1 about two times the distance apart that the fan will hang down (see diagram).
The third length of chain should be centered between the two front lengths of chain and attached to beam number 2. Attach the chains to
the beams using your preferred method.
5. Connect the lengths of chain to the eyebolts on the factory assembled fan head using the chain connectors.
6. Rough focus the fan on your target while on the mechanical lift.
7. Get a co-worker to stand at the target mark. Make sure the power is turned off. Have someone plug the fan in.
Let the fan run for approximately 30 seconds (to get up to speed and settle itself down). With someone on
the oor, someone at the fan, and someone at the power, focus the fan. DO NOT ATTEMPT TO ADJUST THE
FAN WHILE IT IS RUNNING!
8. Remove excess chain with bolt cutters.
HV Ceiling Suspended Assembly Instructions