Assembly Instructions

Note: The most important thing to remember is that if
the fan is at a level near people, it should be equipped
with OSHA approved Patterson nger guards. Please
contact your factory sales representative to order.
1. Secure Part A of the wall bracket to the solid
surface from which you will hang the fan. There
is a single mounting hole on the short end of the
part. Secure part A using a wall anchor, etc.
(Wall anchor not included.) Place a level on the
part.
2. Position part B under part A as shown and
situate part B in such a way so that part A
becomes level. Mark part B for the hole. Attach
part B using the appropriate wall anchor, (not
included).
3. Secure the “U” shaped yoke to the wall bracket
using the supplied 5/8” bolt and nut. If you plan
to add an oscillator, mount the yoke so that it
opens up. The bolt must go through all three
pieces. Check for level and stability.
4. The factory assembled fan head ts inside of the
“U” shaped yoke. Secure the fan head to the
yoke with the supplied nuts. Mount the fan head
so the motor capacitor is in up position.
Note: Due to continual product improvement,
items are subject to change without notice.
Patterson Fan Company, Inc
Blythewood, SC 29016
www.pattersonfan.com
800.768.3985
CW Column Wall Mount Assembly Instructions