Assembly Instructions

Note: Due to continual product improvement,
items are subject to change without notice.
Patterson Fan Company, Inc
Blythewood, SC 29016
www.pattersonfan.com
800.768.3985
Note: Important things to remember are that
the wall mount should be a solid structure
able to support the weight of the fan safely
and that the fan should not be at a height
that will cause employees to bump their
heads. Ideally, the fan should be mounted
to blow into the back of the truck down the
top corner of either side of the trailer.
1. Secure the wall bracket and arm to the solid
surface where you will hang the fan. A struc-
turally secure solid wall or beam is best.
2. Secure the “U” shaped yoke to the arm of the
wall bracket. Use the 5/8” bolt and 5/8” nut
supplied. Tighten the nut onto teh bolt using
a 5/16” box end wrench and ratchet with a
5/16” socket. For clearance reasons, the “U”
shaped yoke must open down.
3. The fan head ts inside the “U” shaped yoke,
the threaded studs on each siide of the fan
ts through the predrilled holes on the “U”
shaped yoke. Secure the fan head to the “U”
shaped yoke with the supplied nuts. Mount
the fan head so that the motor capacitor is
in up position.
TC Truck Cooler Assembly Instructions