Installation Instructions

Page 3 of 4
3. Pull out the source wires from the outlet box. Make wire connections using wire connectors as follows:
---Connect the hot wire (usually black insulation) from the fixture to the black wire from the power source.
---Connect the neutral wire (usually white insulation) from the fixture to the white wire from the power source.
---Connect the fixture grounding wire (usually green insulation or bare wire) to the house grounding wire from the
power source.
Carefully put the wires back into the outlet box.
3
Outlet Box
Wire Connector (C)
Fixture Wire
Source Wire
Key hole slot
Toggle Switch
A
BB
4. Attach the fixture plate to ceiling by inserting two dry wall screw (BB) heads into key hole slots, then slide the fixture
plate (A) to left or right until the heads of the dry wall screw (BB) are located into narrow ends of the key hole slot.
Finally use a screwdriver (not included) to tighten the dry wall screws (BB).
4
5
5. Using Toggle Switch
a. Move the toggle switch to 3000K, the color temperature is set at 3000K.
b. Move the toggle switch to 4000K, the color temperature is set at 4000K.
c. Move the toggle switch to 5000K, the color temperature is set at 5000K.
ASSEMBLY INSTRUCTIONS (continued)
6
Set Screw
C
B
6. Attach two end caps (C) back to fixture plate by securing four set screws.
Turn on the power at fuse or circuit box.
3000K 4000K 5000K