Installation Instructions

Page 2 of 4
Before beginning assembly, installation or operation of product, make sure all parts are present. Compare parts with
package contents list and diagram on previous page. If any part is missing or damaged, do not attempt to assemble,
install or operate the product. Contact customer service for replacement parts.
Tools Required for Assembly (not included): Screwdriver, Phillips Screwdriver, Pliers, Electrical Tape, Wire Cutters,
Safety Glasses, Ladder, Wire Stripper.
PREPARATION
Installation Steps
Important to know
ASSEMBLY INSTRUCTIONS
1. Read all instructions carefully before installation and operation.
2. If you are not familiar with state and local electrical codes, it is recommended that you consult with a qualified
electrician.
3. Do not use in wet locations, use indoors only.
4. Non-replaceable LEDs.
5. Caution: LEDs emit bright light. Avoid looking directly into the light source for prolonged periods to avoid eye
damage.
6. Not to be used with a dimming circuit or any other electronically controlled switch.
7. Specification:
Turn off the power at fuse or circuit box.
1. Unscrew four set screws to remove two end caps (C) from fixture plate (A).
NO.
1
2
24
5
Dimension(inch)
Item #.
348-2131
48 5
348-2130
A
B
C
45
1.5
1.5
Watts
24
A
B
C
C
A
1
Set Screw
2. Attach the fixture plate (A) to the location where you want to install, mark the target where is for two anchor (AA) to
secure fixture plate (A) to the ceiling. Remove the fixture plate (A) and drill two holes on the target. Hammer the
anchors (AA) to target holes tightly, and then secure the dry wall screws (BB) to anchors in part way.
A
2
AA
BB
Ceiling
Outlet Box
Anchor