Installation Instructions

4
ASSEMBLY INSTRUCTIONS (continued)
5.
Prepare wire by stripping 3/4 in. of insulation from
wire ends using wire strippers (not included).
Make wire connections with wire connectors (DD)
provided as follows:
Connect BLACK wire from outlet box to BLACK
wire from the fixture (A).
Connect WHITE wire from outlet box to the
WHITE wire from the fixture (A).
Connect BARE/GREEN wire from outlet box to
BARE ground wire from fixture (A).
NOTE: If the outlet box wiring does not have a
GREEN/GROUND wire, the BARE/GREEN wire
from the fixture (A) should be attached to the
GREEN SCREW (labeled GND) on the mounting
plate (AA).
NOTE: Screw wire connectors (DD) on in a
clockwise direction.
WARNING: Never connect ground wire to WHITE
or BLACK power supply wires.
Wrap all wire connectors (DD) with electrical tape
as an extra safety measure.
Carefully arrange excess wiring and wire
connectors (DD) within outlet box.
WARNING: Make sure no bare wire or wire strands
are visible after making connections.
6.
Outlet Box
7.
Attach fixture (A) to mounting plate (AA) using
the mounting plate screws (BB) previously
removed (Step 3, page 3).
NOTE: Fixture (A) can be installed with the
socket facing either up or down.
NOTE: Before tightening mounting plate
screws (BB) completely, use level (not
included) to check fixture (A) -- adjust if
necessary.
A
Outlet Box
*
GREEN/
GND Screw
white
bare
white
bare/
green
black
black
BB
BB
A
DD
DD
DD
AA
AA
DD