Installation Instructions

SAFETY INFORMATION

Read all safety precautions and installation instructions carefully before installing or servicing this

fixture. Failure to comply with these instructions could result in potentially fatal electric shock and/or property damage.

It is recommended that a qualified electrician perform all wiring. This fixture must be wired in accordance with all national and

local electrical codes.

WARNING: Do not handle any energized fixture or attempt to energize any fixture with wet hands or while standing on a

wet or damp surface or in water.

WARNING: To reduce the risk of electrical shock, and to assure proper operation, this fixture must be adequately ground-

ed. To accomplish proper grounding, there must be a separate ground wire (green) contact between this fixture and the ground

connection of your main power supply panel.

CAUTION: Make sure that the power source conforms to the requirements of the fixture (see labels on fixture housing). This

fixture is designed for use in a 120-277 VAC, 50/60Hz.

CAUTION: Make sure power is off at fuse or circuit breaker box. Check wires for damage or scrapes. If power supply wires are

within three inches of the LED driver power supply, use wire suitable for at least 90° C (194° F). NOT FOR USE WITH

DIMMING CIRCUITS.

This fixture is intended to be used for general indoor lighting in dry or damp locations only.

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to

operate the equipment.

Any modifications to this fixture may void the warranty and interfere with the safe operation of

the luminaire.

PREPARATION

Disconnect electrical power at fuse or circuit breaker box before installing or servicing any part of this fixture.

Carefully remove the fixture from the carton, and check that all parts are included.

If parts are missing or damaged, do not attempt to assemble the product. Contact customer service at 1-800-873-2326

Monday - Friday, 8:00 am-4:30 pm Central Standard Time for replacement parts.

Estimated assembly time: 45 minutes.

• (2) Mounting Screws • Phillips Screwdriver • Stud finder

• (2) Wall Anchors • Pliers • Electrical Tape

• Eye Protection • Wire Cutter

• Ladder • Wire Stripper

REQUIRED TOOLS