Installation Instructions

1. Remove the spring catches from the sockets, and remove the back plate from the mounting plate.
2. Fix the mounting plate to the wall.
a) For wood wall:
Attach the mounting plate to the outlet box by using two mounting screws, then secure the
dry wall screws through the set holes to the wall.
b) For cement wall:
Place the mounting plate to the outlet box and mark the target on the wall from the set hole
for drilling two holes. Remove the mounting plate from the outlet box. Insert the anchors into
the drilled holes, then attach the mounting plate to the outlet box by using two mounting
screws. Secure the dry wall screws through the set holes into the anchors.
3. Pull out the outlet wires and the house grounding wire from the outlet box. Make wire connections
using the wire nuts:
---The black wire from the fixture to the black wire from the power source.
---The white wire from the fixture to the white wire from the power source.
---Attach the fixture grounding wire to the mounting plate with the green grounding screw. Then
connect it to the house grounding wire with a wire nut.
Carefully put the wires back into the outlet box.
4. Reattach the back plate and spring catches back to the mounting plate.
5. Install bulbs (not included). See relamping label at socket area or packaging for maximum allowed
wattage.
6. Turn on the power at the main fuse or circuit breaker box.
Set Hole
Outlet Box
House Grounding Wire
Anchor
Socket
Mounting Plate
Dry Wall Screw
Mounting Screw
Green Grounding Screw
Back Plate
Wire Nut
Fixture Wire
Spring Catch
ASSEMBLY AND INSTALLATION
INSTRUCTIONS
WARNING: BE SURE TO SHUT OFF POWER AT THE MAIN FUSE OR CIRCUIT
BREAKER BOX BEFORE INSTALLING OR SERVICING THIS FIXTURE.
350-6615 / 350-6616
100429
NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2.
Customer Service: 1-800-887-6326 (weekdays 9 a.m. – 5 p.m. CST)
3. READ AND SAVE THESE INSTRUCTIONS.
Bulb Type G Max.60W
(not included)