Installation Instructions

Patriot Lighting

140402

352-5807

WARNING:

TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF

POWER WHILE INSTALLING OR SERVICING THIS FIXTURE.

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.

2. Customer Service: 1-800-887-6326 (weekdays 9 a.m. – 5 p.m. CST)

3. Read and save these instructions.

Turn off the power at fuse or circuit box.

Fixture

Outlet Box

1" Screws

Lock Nut

Fixture Screws

Cross Bar

Outlet Box

Hardware Package:

(1 SET)

1. Thread two fixture screws through holes

cross bar as shown in Fig. 1, then secure

them with two lock nuts. Adjust the length of

the fixture screws if necessary - see Fig. 1a.

2. Attach the

cross bar to the outlet box by

using

(2) 1" screws.

3. Pull out the source wires from the outlet box.

Make wire connections using wire nuts as shown

in Fig. 2:

A - Connect the black wire from fixture to the

black wire from power source.

B - Connect the white wire from fixture to the

white wire from power source.

C -

Attach the fixture grounding wire to the

mounting plate with the green grounding

screw. Then connect it to the house

grounding wire with a wire nut.

Carefully put wires back into the wall outlet box.

Fig. 1

Fig. 2

PAGE 1
ASSEMBLY AND INSTALLATION INSTRUCTIONS 352-5807 WARNING: TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF POWER WHILE INSTALLING OR SERVICING THIS FIXTURE. NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements. 2. Customer Service: 1-800-887-6326 (weekdays 9 a.m. – 5 p.m. CST) 3. Read and save these instructions. Hardware Package: (1 SET) Fig. 1 Cross Bar Fig.
PAGE 2
Fig. 3 Fixture Screw Holes Ball Nuts 4. Attach the fixture to the cross bar through screw holes as shown, and secure it with Ball Nuts. Adjust length of fixture screws if needed to achieve secure fit. (see step 1) 5. Attach the glass shades to the fixture, and secure them with the socket rings. Glass Shade Socket Ring Bulb Type A Max.100W (not included) 6. Install bulbs (not included). See relamping label at socket area or packaging for maximum allowed wattage. Turn on the power at fuse or circuit box.