Installation Instructions

ManualsBrandsPatriot Lighting ManualsIndoor LightingLodge 2-Light Noachian Stone Vanity Light

Glass Shade

Mounting Plate

Dry Wall Screw

Set Hole

House Grounding Wire

Wire Nut

Outlet Box

Green Grounding Screw

Fixture Wire

Fixture Grounding wire

Screw

Mounting Screw

Anchor

Bolt Nut

Socket Ring

Glass Holder

Back Plate

1. Unscrew the bolt nuts from the back plate, and remove the mounting plate.

2. Attach the mounting plate to the wall.

a) If the wall material is wood:

Attach the mounting plate to the wall by using two mounting screws, then

secure the dry wall screws through the set holes to the wall.

b) If the wall material is cement:

Place the mounting plate to the wall and mark the target on the wall from the

set hole for drilling two holes. Remove the mounting plate. Drill the holes and

thread the anchors into the holes, then attach the mounting plate to the outlet

box by using two mounting screws. Secure the dry wall screws through the set

holes into the anchors.

3. Pull out the outlet wires and the house grounding wire from the outlet box. Make

wire connections using the wire nuts:

---The black wire from the fixture to the black wire from the power source.

---The white wire from the fixture to the white wire from the power source.

---Attach the fixture grounding wire to the mounting plate with the green grounding

screw. Then connect it to the house grounding wire with a wire nut.

Carefully tuck the wires back into the outlet box.

4. Attach the back plate to the mounting plate by using the screws, then secure

them with the two bolt nuts.

5. Attach the glass shades to the glass holders, then secure them with the socket rings.

6. Install bulbs (not included). See relamping label at socket area or packaging for

maximum allowed wattage.

7. Turn on the power at the main fuse or circuit breaker box.

VL33022/VL33023/ VL33024

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

WARNING: BE SURE TO SHUT OFF POWER AT THE MAIN FUSE OR CIRCUIT

BREAKER BOX BEFORE INSTALLING OR SERVICING THIS FIXTURE.

NOTE: Before installing, consult local electrical codes for wiring and grounding requirements.

0600216

Summary of content (1 pages)

PAGE 1
ASSEMBLY AND INSTALLATION INSTRUCTIONS VL33022/VL33023/ VL33024 WARNING: BE SURE TO SHUT OFF POWER AT THE MAIN FUSE OR CIRCUIT BREAKER BOX BEFORE INSTALLING OR SERVICING THIS FIXTURE. NOTE: Before installing, consult local electrical codes for wiring and grounding requirements. Anchor Socket Ring Mounting Screw Mounting Plate Glass Shade Back Plate Screw Outlet Box Wire Nut House Grounding Wire Set Hole Dry Wall Screw Green Grounding Screw Bolt Nut Glass Holder Fixture Wire Fixture Grounding wire 1.