Installation Instructions

Page 3 of 4
ASSEMBLY INSTRUCTIONS (continued)
Installation Steps
Turn off the power at fuse or circuit box.
1. Attach the template (CC) to the outlet box.
1
CC
2. Mark the position of the four holes on the ceiling
where the anchors will be placed. Remove the
template (CC) and drill four holes on the target.
2
CC
3. Insert the four anchors (BB) through the holes of
the ceiling, and then insert four dry wall screws (AA)
to anchors in half way.
3
AA
A
A
A
B
B
C
C
BB
--- Connect the hot wire (usually black insulation)
from the fixture to the black wire from the power
source.
--- Connect the neutral wire (usually white insulation)
from the fixture to the white wire from the power
source.
--- Connect the fixture grounding wire (usually green
/ yellow insulation or bare wire) to the house
grounding wire from the power source.
● If need connect the dimmer, please remove two small
wire connectors (EE) from the rest of two wires, and
make wire connections using small wire connectors (EE)
as follow:
--- Connect the purple wire from the fixture to the
positive wire (usually purple insulation) from the
dimmer.
--- Connect the grey wire from the fixture to the negative
wire (usually grey insulation) from the dimmer.
● If not, do not remove the two small wire connectors (EE),
and make sure the small wire connectors (EE) are
secured in wires.
Carefully tuck all wires back into the outlet box.
6
AA
5. Pull out the source wires from the outlet box. Make
wire connections using big wire connectors (DD)
as follow:
5
AA
DD
EE
6. Attach the fixture body (A) to ceiling by inserting four
dry wall screw (AA) heads into key hole slots, then
slide the fixture body (A) until it is locked in place,
secure the dry wall screws (AA) tightly.
7
7. Attach the safety lock arm(C) to fixture body (A)
and frame (B), fix the frame (B) to fixture body (A)
by magnet.
NOTE:This fixture relies on magnet to fix the metal
frame, please avoid high frequency impact
and stay away from high magnetic field
environment.
Turn on the power at fuse or circuit box.
4
4. Remove frame(B) and the safety lock arm(C)
from the fixture body (A).
1
2
3
4
DD
EE