Installation Instructions

Page 3 of 4

ASSEMBLY INSTRUCTIONS (continued)

5. Attach the housing (A) to ceiling by inserting

four dry wall screw (AA) heads into key hole

slots, then slide the housing (A) to left or right

until the heads of the dry wall screw (AA) are

located into narrow ends of the key hole slot.

Use a screwdriver (not included) to tighten the

dry wall screws (AA).

3. Mark the position of the four center holes of key

hole slots on the ceiling where the anchors will be

placed (See Fig.3a).

Remove the housing (A) from the outlet box, and

drill four holes on the target.

Insert the anchors (BB) through the holes of the

ceiling, and then insert the dry wall screws (AA) in

anchors in part way (See Fig.3b).

6. Attach the acrylic shade(B) to the housing(A),

turn six latches(C) until they are closed.

Turn on the power at fuse or circuit box.

4. Pull out the source wires from the outlet box. Make

wire connections using wire connectors (CC)

as follow:

--- Connect the hot wire (usually black insulation)

from the fixture to the black wire from the power

source.

--- Connect the neutral wire (usually white

insulation) from the fixture to the white wire from

the power source.

--- Connect the fixture grounding wire (usually green

/ yellow insulation or bare wire) to the house

grounding wire from the power source.

Carefully tuck all wires back into the outlet box.

Key Hole Slot

Spare Parts List:

Assembly Kit

5910MM (1 SET)

Anchor

Dry Wall Screw

Acrylic Shade With Marbe Texture

9993AC

Wire Connector

The following parts are available for re-order if damaged or missing. Call us toll-free at 1-800-887-6326

Mounting Screw