Installation Instructions

Page 3 of 4
ASSEMBLY INSTRUCTIONS (continued)
4
5
5. Slip the LED strip panel down through the clips, and
until the LED strip panel is locked in place.
Attach the shade (A) to the housing (B) and secure
them with the ten clamps (C).
4. Make wire connections using wire nuts as follow:
--- Connect the hot wire (usually black insulation) from
the driver to the black wire from the cord.
--- Connect the neutral wire (usually white insulation)
from the driver to the white wire from the cord.
--- Connect the grounding wire from the LED strip
panel (usually green/yellow insulation) to the
grounding wire from the cord.
Carefully tuck all wires back into the housing (B).
3
GG
B
B
A
Cord
Driver
LED Strip
Panel
6
Clip
Cord
3. Unscrew the cord grip (GG) and install it on the end
of the housing (B).
Loosen the cord grip (GG) on one end of the housing,
feed the cord (not included) into the housing through
the cord grip (GG), then tighten the cord grip (GG) to
secure the cord.
LED Strip
Panel
C
6. Mark two spots on the ceiling 28-7/8" ~31-5/8" apart
for the mounting U brackets.
28-7/8"~31-5/8"
B
BB
CC
AA
7
7. Attach the U brackets (AA) to target, mark the position
of the four holes on the ceiling or wall where the
anchors will be placed. And then remove the U
brackets (AA), and drill four holes on the target.
Insert the anchors (CC) through the holes of the
ceiling or wall, re-attach the U brackets to ceiling or
wall by aligning predrilled holes. And then attach the
drywall screws (BB) through the holes of the U
brackets (AA) and secure the drywall screws (BB) to
the anchors (CC).
AA
8
GG
8. Attach the fixture to the U brackets (AA) by sliding
one side of the fixture into U brackets (AA) first, and
then press and push the other side of the fixture into
the U brackets (AA).
Connect the wires from the cord grip (GG) to the main
power cord.
Turn on the power at fuse or circuit box.