Installation Instructions

Page 3 of 4

ASSEMBLY INSTRUCTIONS (continued)

CARE AND MAINTENANCE

Caution: Before attempting to clean the fixture, disconnect the power to the fixture by turning the breaker off or

removing the fuse from the fuse box.

This LED light fixture is made from quality materials that will last many years with minimum care. You may want to

periodically clean the fixture with a soft cloth. To maintain the best appearance of the fixture, do not use cleaners with

chemicals, solvents or harsh abrasives. Do not use liquid cleaner on the LEDs, LED drive, or wiring inside the light

fixture.

Spare Parts List:

Assembly Kit

5735MM (1 SET)

P1 Wire Nut

P4 Wire Nut

4. ● Remove knockout for input power source wires.

● Pull out the fixture wires. Make wire connections using

wire nuts (BB) as follow:

--- Connect the hot wire (usually black insulation) from

the fixture to the black wire from the power source.

--- Connect the neutral wire (usually white insulation)

from the fixture to the white wire from the power

source.

--- Connect the fixture grounding wire (usually green /

yellow insulation or bare wire) to the house

grounding wire from the power source.

● If need connect the dimmer, please remove two P1

wire nuts(AA) from the rest of two wires, and make

wire connections using wire nuts (AA) as follow:

--- Connect the purple wire from the fixture to the

positive wire (usually purple insulation) from the

dimmer.

--- Connect the grey wire from the fixture to the negative wire (usually grey insulation) from the dimmer.

If not, do not remove the two P1 wire nuts (AA), and make sure the P1 wire nuts (AA) are secured in wires.

Carefully tuck all wires back into the fixture.

● Re-attach the enclosure cover to the back of fixture, and secure it with the set screw.

Turn on the power at fuse or circuit box.

Set Screw

Enclosure

Cover

Knockout

The following parts are available for re-order if damaged or missing. Call us toll-free at 1-800-887-6326

Enclosure

Cover

Set Screw

3. Remove the set screw to separate the enclosure cover.